opinions of the arai xd helmet?

DSN_KLR650
Post Reply
gpokluda
Posts: 406
Joined: Wed Dec 05, 2001 8:50 am

opinions of the arai xd helmet?

Post by gpokluda » Mon Apr 18, 2005 5:39 pm

Yep. Ditto. I wear mine regularly and the peak behaves itself until you get in the 85mph + range on an unfaired bike. Quieter than I thought it would be too. Gino Rider Valley Motorcycles www.rvmc.com
--- In DSN_KLR650@yahoogroups.com, "Wolfy" wrote: > I just got a XD and I love to so far. Nice and quiet on the high way to very > little pull from the visor when doing a head check at highway speeds. I like > the idea of the flip up shield because you can also use it with goggles. I > ride with tinted in the day then take them off at night and flip the shield > down.

G Crites
Posts: 3
Joined: Tue Apr 05, 2005 7:32 pm

a12 soft above 5k rpm

Post by G Crites » Mon Apr 18, 2005 8:05 pm

Ok, here goes. I recently had to swap carb bodies due to some damage. The new (used) body ran fine on another bike. Now that it is on my bike, here's what's happening: 1. In a roll-on situation, power goes soft above 5K RPM 2. When taking off from a light at full throttle, sometimes full power is available at all RPMs in all gears until I let off. 3. If I'm riding at full throttle in the low power situation trapped at 75mph, after about 1/2 mile full power will sometimes return in a surge, taking me to 95 or more in a normal fashion. 4. Revs buld very slowly above 5K. Some popping on decel, which never happened before. 5. Carb is spotless (checked 3 times), floats move freely, mainjet and all orfices are clear. Fuel lines are clear, vent lines are clear, petcock is clean. Slide slides. All parts are in there. 6. New gas 7. Valves adjusted 50 miles ago, slappy 'n happy. 8. Clean air filter and spark plug 9. Pilot screw 2 turns out, thin washer on stock needle, stock jets, everything else stock except for de-tweeteied muffler. 10. No rags in airbox or intakes. 11. Bike idles perfectly, runs cool, and runs great below 4,500-5K. Could the float level have come out of adjustment while I was messing with everything? This is the only thing left I can think of... any ideas? I think the fact that every once in a while I get full power is a big flag. Thanks.

Post Reply

Who is online

Users browsing this forum: No registered users and 25 guests