-
PIETER G LUND
- Posts: 8
- Joined: Mon Oct 08, 2001 8:12 pm
Post
by PIETER G LUND » Fri Nov 16, 2001 10:28 pm
Help!! When I removed my rear brake shoes I failed to notice a looped structure bolted onto one shoe on each side. I have looked at drawings, and pictures and catalogues and can't figure out where these things belong, or what they do. Any suggestions??
Breakless in California, Pete
MGTC 5288
-
Robert Grunau
- Posts: 100
- Joined: Mon Oct 08, 2001 6:18 am
Post
by Robert Grunau » Sat Nov 17, 2001 3:42 am
I think you will find this looped structure is the holder to locate the front end of the horizontal spreader bar on the Handbrake lever assembly, p/n MG700/21 or 22, that activates the rear brakes from the hand brake. It is bolted in place and goes to the inside of the front leading shoe. Its official name from TC parts book is Retaining plate for pushrod, part number MG700/170 . Regards from Canada, Bob Grunau Help!! When I removed my rear brake shoes I failed to notice a looped structure bolted onto one shoe on each side. I have looked at drawings, and pictures and catalogues and can't figure out where these things belong, or what they do. Any suggestions?? Breakless in California, Pete MGTC 5288
Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service.
Users browsing this forum: No registered users and 12 guests