Cycle fenders

[BobAlley747@aol.com]

I'm installing cycle fenders on my TC and am looking for a supplier for the
rubber gromet that fits between the stay bar and the fender. I have seen them
on older cars( PA's and MMM's) They are round and stepped. I have emailed Moss
Europe but have not gotten a response. Does anyone know of another supplier
that might carry such an item?
Thanks Bob
TC6198


[Non-text portions of this message have been removed]

[MIKEFRAN@aol.com]

Bob

On this side of the pond you may want to try Abingdon Spares as they carry a
small amount of pre-war supplies. You could also try Tom Metcalf at Safety
Fast Restoration in Ohio, 419-525-0799, who does MMM restorations.

Your best bets however are the two largest suppliers of MMM parts in the
U.K., Sports & Vintage, tel. 01939 210458 fax 01939 210644 or Barry Walker tel.
01789 400181 fax 01789 400230.

You will probably also require the large, round headed, chrome mounting
bolts that are used in conjunction with the rubber washers you described,
available from the same sources.

Mike Francks


[Non-text portions of this message have been removed]

[BobAlley747@aol.com]

I'm about to make another batch of cycle fenders. If anyone is interested
contact me offline. Thanks Bob


[Non-text portions of this message have been removed]

[BobAlley747@aol.com]

I wasn't expecting so many responses on the cycle fenders.so I need to know
who is serious and who is window shopping. I'm about to order the aluminum and
need to get an accurate count. There will be a deposit required for each
set.
Thanks
Bob


[Non-text portions of this message have been removed]

[Jim Buell]

During the planning stages of the racing version of TC9806 I acquired a
complete set of aluminum racing fenders (both front and rear) along with
aerofoil wing stays (front and lower front), chrome fixing bolts and rubber
washers. Since then I have taken the fenders on the car in a different
direction so these fenders and pieces are excess to my needs. Before I put
them on e-bay I thought I would offer them to the group.



If you are interested, please contact me off-list



Jim Buell

TC 9806

Blanchard, ID





[Non-text portions of this message have been removed]

[Boballey747]

A friend of mine bought a TC to restore that came with new cycle fenders. He's going to put original fenders on and would like to sell the cycle ones. If interested contact me and I will send pictures. Price $300
Cheers

Sent from my iPad

[Boballey747]

I didn't realize the demand for cycle fenders. I had over a dozen enquires the first day. Bad news they sold almost immediately good news there is a second pair. Bad news is the second pair have a couple holes where the previous owner test fitted some brackets. Good news is they come with bottom panels(below the bonnet) and a couple brackets. $250 for the lot pictures on request. Act fast as they will probably be gone today.
Cheers


Sent from my iPad

[Boballey747]

The fenders have been sold.

Sent from my iPad

[Ron Engstrom]

Attachments :

1. [url=file:///C:\Users\Steve\AppData\Local\PG Offline 4\Attachments\\image1.JPG]image1.JPG[/url]

TCers,

Anybody interested in two cycle fenders for a project let me know. They were mounted on the rear of the car I just finished up. Comes with two brackets to hold them in place. Call or write with questions, as I have never mounted cycle fenders to a TC.

Thanks,
Ron 530-521-4329