Re: TC Floorboards

Charles Hill · Post by **Charles Hill** » Fri Nov 26, 1999 12:48 pm

Jack, please resend your email address - or check to make sure your
message filter will accept messages from me. My reply off list was
bounced back.

Charles Hill

Jeff Fields · Post by **Jeff Fields** » Mon Apr 09, 2001 3:22 pm

Is it necessary to order the screws for fixing the floorboards in a TC? Or
may I purchase them at the local hardware.....if so, what is specific size
and type?

Please take me off the list due to holiday from 12 APR-22APR.
Safety Fast !
Jeff F

440.355.MGMG (Home)
440.897.2309 (new cell)

Frank O_ The Mountain · Post by **Frank O_ The Mountain** » Mon Apr 09, 2001 4:06 pm

In a message dated 4/9/01 3:24:42 PM Pacific Daylight Time, jfield@leeca.org
writes:

>

Jeff, if your local hardware store carries BSF countersunk screws...then
there is your source....otherwise order the kit from Moss or Abingdon.

I believe you'll have to take yourself off the list by visiting
www.yahoogroups.com

Terry

Jim · Post by **Jim** » Sat Apr 08, 2006 11:57 am

Hi Group-

I need some advice. I am ready to mount my floorboard and am wondering if there should be a weather proofing or a seal between the floor boards and the tunnel flange, the side frame, and the foot ramp. I have the metal angles that mount the rear of the floorboards to the tunnel ramp and that should seal that area.

Any advice will be greatly appreciated

Jim Buell
TC 9806

[Non-text portions of this message have been removed]

Peter Roberts · Post by **Peter Roberts** » Sat Apr 08, 2006 1:39 pm

Jim,

Not a real good idea. You will remove those floorboards one day and rue
having put down sealant. I have driven in driving rain many many times and
never had a leakage problem...at least not from below!

_Peter

----- Original Message -----
From: "jim"
To:
Sent: Saturday, April 08, 2006 2:57 PM
Subject: [mg-tabc] TC Floorboards

> Hi Group-
>
> I need some advice. I am ready to mount my floorboard and am wondering if
> there should be a weather proofing or a seal between the floor boards and
> the tunnel flange, the side frame, and the foot ramp. I have the metal
> angles that mount the rear of the floorboards to the tunnel ramp and that
> should seal that area.
>
> Any advice will be greatly appreciated
>
> Jim Buell
> TC 9806
>
> [Non-text portions of this message have been removed]
>
>
>
>
> Yahoo! Groups Links
>
>
>
>
>
>
>

Wilsons Sandbox