DSN_KLR650
-
Tengai Mark Van Horn
- Posts: 1922
- Joined: Tue Nov 19, 2002 8:31 pm
Post
by Tengai Mark Van Horn » Tue Aug 27, 2013 4:49 pm
SeaFoam is a mix of isopropanol, hydraulic fluid
and Coleman white gas. I don't think it will lift
paint... unless left there for a loooooong time.
Mark
>
>
At 2:38 PM -0700 8/27/13, mark ward wrote:
>I have an 07, I noticed that near the tank neck
>and down the tank a bit, a strip (.5 x 1
>inch) bubbled up, like when you put paint
>stripper on something painted.
>
>I guesting I most have splashed a little sea
>foam on it, because I can't think what else it
>may have been?
-
KLRDON
- Posts: 38
- Joined: Sun Apr 30, 2006 5:31 pm
Post
by KLRDON » Tue Aug 27, 2013 6:27 pm
Hi all,
Q 1 - Just installed 1" lowering links on 02 KLR. Does chain adjustment
need to be changed? Thought is, no. Tight spot which we adjust for is
still the same.
Q 2 - What chemical is good to remove powder coat paint. Need to weld a
crack in a Happy Trails engine guard that runs along the original weld.
Any thoughts on preventing a crack along the side of the new weld?
Best to all!
Regards,
Don M
Atlanta, GA
Users browsing this forum: No registered users and 30 guests