anyone find my klr seat on i- 10 east bound ???

DSN_KLR650
Mike Jones
Posts: 10
Joined: Mon Jun 20, 2005 7:09 am

turn signals

Post by Mike Jones » Mon May 15, 2006 8:18 am

Does anyone know of an easy way to install some sort of sound when using turn signals on a KLR 650. I've ridden bikes which have turn signals which beep. I tend to forget to turn off the turn signal after I've made the turn. I'm sure there are many others who experience the same problem. --------------------------------- Yahoo! Messenger with Voice. Make PC-to-Phone Calls to the US (and 30+ countries) for 2 /min or less. [Non-text portions of this message have been removed]

W.V. Doran
Posts: 415
Joined: Fri Jul 27, 2001 3:36 pm

turn signals

Post by W.V. Doran » Mon May 15, 2006 8:29 am

Here's an easy way..... http://www.dirtly.com/index_html_8.html Mike Jones wrote: Does anyone know of an easy way to install some sort of sound when using turn signals on a KLR 650. I've ridden bikes which have turn signals which beep. I tend to forget to turn off the turn signal after I've made the turn. I'm sure there are many others who experience the same problem. WVDoran Scottsdale, AZ --------------------------------- Blab-away for as little as 1 /min. Make PC-to-Phone Calls using Yahoo! Messenger with Voice. [Non-text portions of this message have been removed]

James and Joyce
Posts: 19
Joined: Mon May 16, 2005 10:05 am

turn signals

Post by James and Joyce » Mon May 15, 2006 7:52 pm

From: "Mike Jones" jones22mm@... Date: Mon May 15, 2006 6:18am(PDT) Subject: Turn Signals Does anyone know of an easy way to install some sort of sound when using turn signals on a KLR 650. I've ridden bikes which have turn signals which beep. I tend to forget to turn off the turn signal after I've made the turn. I'm sure there are many others who experience the same problem. I use piezo buzzers from Radio Shack. they have several different sizes with different tones. I put two, one for each side on with 3M two sided tape mounted them on back of fairing . the wires are small enough to slide into the connectors for the light by taking it apart. .the wire for the buzz will fit in the end of the bullet end fold along side of bullet then reconnect easy and cheap run from two dollars up to about ten I have run for many a mile in the rain without problems but have had some fail after a year or so who knows why[vibration water temperature age?] they are cheap I just replace them . I even use a different tone for each side just for the hell it You will find that after awhile you won't need them but they do sound good. Jim Arkansas ---------- No virus found in this outgoing message. Checked by AVG Free Edition. Version: 7.1.392 / Virus Database: 268.5.6/339 - Release Date: 5/14/2006 [Non-text portions of this message have been removed]

chris kelty
Posts: 77
Joined: Fri Nov 21, 2003 2:58 pm

anyone find my klr seat on i- 10 east bound ???

Post by chris kelty » Sun Aug 01, 2010 9:42 pm

I decided to trailer across the desert from Ventura to Phoenix,  forgot to bolt down the seat and it bounced off.  Anyone got a seat for sale ??  my bike is an 2004.   I have an extra seat ( at home ) for a DR650  do they fit on KLR's ???  I'm heading for New Mexico and then to Colorado  

Post Reply

Who is online

Users browsing this forum: No registered users and 16 guests