sold my klr-remove me from group mail list

DSN_KLR650
Post Reply
thomas cole
Posts: 16
Joined: Sat May 19, 2007 1:13 am

mini siganl light flasher issue.

Post by thomas cole » Sat May 19, 2007 2:13 am

Gentlemen, I purchased a set of mini sinal lights off e-bay several months ago. For my 06 KLR 650 I installed them with out problems, how ever.... I went to change out the flasher and it was not even remotely close the one the company sent me. They sent me one that was square and had two prongs in the shape of an "L". As you may or may not know the stock signal light flasher is round with two rows of three flat prongs. The lights do light up when turned on but don't flash. My question is the same I asked the company I purchased them from. "Does a replacement flasher work/exsist for this appliaction? If so where could I get it?" Why won't the stock flasher work? The lights have 8 watt bulbs. The company said I should splice a "10 ohm 10 watt resister in parralle to each light or a pair (front or rear)". I saw the picture of the resistor they sent (see attached photo), but rather than cutting & sodiering that many wires I would rather just replace the flasher, and then only once as I don't like to take the fuel tank off very much. Does any one know what I'm talking about? I really like the look of these lower profile lights now that ther're on. I just want them to work as planned. PS: this is my first post in this forum. Tom Cole Morinville, Alberta --------------------------------- All new Yahoo! Mail --------------------------------- Get news delivered. Enjoy RSS feeds right on your Mail page. [Non-text portions of this message have been removed]

thomas cole
Posts: 16
Joined: Sat May 19, 2007 1:13 am

mini siganl light flasher issue.

Post by thomas cole » Sat May 19, 2007 2:16 am

Gentlemen, I purchased a set of mini sinal lights off e-bay several months ago. For my 06 KLR 650 I installed them with out problems, how ever.... I went to change out the flasher and it was not even remotely close the one the company sent me. They sent me one that was square and had two prongs in the shape of an "L". As you may or may not know the stock signal light flasher is round with two rows of three flat prongs. The lights do light up when turned on but don't flash. My question is the same I asked the company I purchased them from. "Does a replacement flasher work/exsist for this appliaction? If so where could I get it?" Why won't the stock flasher work? The lights have 8 watt bulbs. The company said I should splice a "10 ohm 10 watt resister in parralle to each light or a pair (front or rear)". I saw the picture of the resistor they sent (see attached photo), but rather than cutting & sodiering that many wires I would rather just replace the flasher, and then only once as I don't like to take the fuel tank off very much. Does any one know what I'm talking about? I really like the look of these lower profile lights now that ther're on. I just want them to work as planned. PS: this is my first post in this forum. Tom Cole Morinville, Alberta --------------------------------- All new Yahoo! Mail - --------------------------------- Get a sneak peak at messages with a handy reading pane. --------------------------------- Be smarter than spam. See how smart SpamGuard is at giving junk email the boot with the All-new Yahoo! Mail [Non-text portions of this message have been removed]

a14@att.net
Posts: 338
Joined: Mon Jan 03, 2005 7:06 pm

mini siganl light flasher issue.

Post by a14@att.net » Sat May 19, 2007 5:09 am

I think the part you are referring to may be the fan relay or starter circuit relay. The turn signal relay is as you described the replacement with a barb on it to attach to its rubber mount. You need to remove the tank and look behind the steering stem in the triangular part of the frame from the radiator/fan side to find it. The replacement you have should fit the plug but you may need to use a couple tie-wraps to attach it to the rubber mount. Walt
> Gentlemen, I purchased a set of mini sinal lights off e-bay several months ago. > For my 06 KLR 650 I installed them with out problems, how ever.... I went to > change out the flasher and it was not even remotely close the one the company > sent me. They sent me one that was square and had two prongs in the shape of an > "L". As you may or may not know the stock signal light flasher is round with two > rows of three flat prongs. The lights do light up when turned on but don't > flash. My question is the same I asked the company I purchased them from. "Does > a replacement flasher work/exsist for this appliaction? If so where could I get > it?" Why won't the stock flasher work? The lights have 8 watt bulbs. The company > said I should splice a "10 ohm 10 watt resister in parralle to each light or a > pair (front or rear)". I saw the picture of the resistor they sent (see attached > photo), but rather than cutting & sodiering that many wires I would rather just > replace the flasher, and then only > once as I don't like to take the fuel tank off very much. Does any one know > what I'm talking about? I really like the look of these lower profile lights now > that ther're on. I just want them to work as planned. > > PS: this is my first post in this forum. > > Tom Cole > Morinville, Alberta >

Glenn
Posts: 195
Joined: Wed May 25, 2005 9:19 pm

sold my klr-remove me from group mail list

Post by Glenn » Sat May 19, 2007 7:35 am

We'll keep the light on for ya...

Post Reply

Who is online

Users browsing this forum: No registered users and 20 guests