brake help!!

[Kelley Kinser]

How dare anyone speak ill of the socialist wench! Take them to the dunking pool! Or, better yet, burn them at the stake!!! Any good socialist state like Minnesota, or the Peoples' Republic of Western Washington (where I live) should send them to the Gulags where all good dissenters belong! Kelley.......... __________________________________ Do you Yahoo!? Yahoo! Calendar - Free online calendar with sync to Outlook(TM). http://calendar.yahoo.com

[wannabsmooth1]

Why, Squasher - you use Slick Willie - of course! Sorry, I could NOT resist! Mike --- In DSN_klr650@yahoogroups.com, "kcuf_oohay_666" wrote:

> So, what oil should I put in the KLR? > >

[dooden]

Fish Oil of course, just like the factory.. Dooden --- In DSN_klr650@yahoogroups.com, "kcuf_oohay_666" wrote:

> So, what oil should I put in the KLR? > >

[D Critchley]

Hillary who ? DC Kelley Kinser wrote:

>How dare anyone speak ill of the socialist wench! > Take them to the dunking pool! Or, better yet, >burn them at the stake!!! > >Any good socialist state like Minnesota, or the >Peoples' Republic of Western Washington (where I >live) should send them to the Gulags where all >good dissenters belong! > >Kelley.......... > >__________________________________ >Do you Yahoo!? >Yahoo! Calendar - Free online calendar with sync to Outlook(TM). >http://calendar.yahoo.com > >List sponsored by Dual Sport News at www.dualsportnews.com. List FAQ courtesy of Chris Krok at: www.bigcee.com/klr650faq.html >Unsubscribe by sending a blank message to: >DSN_klr650-unsubscribe@yahoogroups.com . > > > >Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/ > > > > >

[klr_a4]

I get my news from http://www.rense.com Cheers, Conall --- In DSN_klr650@yahoogroups.com, "Russell Scott" wrote:

> If you want to read something with real humor from my favorite news

and

> political web site, check out Ann Coulter, my favorite political

commentator

> . Sorry Savage Love, but bathroom humor is no match for the beauty, > intelligence, and humor of a real women. You might even learn

something

> that can make you a better person. Just call this a bonus for

being on the

> greatest motorcycle list on the planet. > > http://www.worldnetdaily.com/news/article.asp?ARTICLE_ID=33036 > > R > > > ----- Original Message ----- > > From: "Zachariah Mully" > > To: "Russell Scott" > > Cc: "KListeRs" DSN_klr650@yahoogroups.com> > > Sent: Thursday, June 12, 2003 1:49 PM > > Subject: Re: [DSN_klr650] NKLR - Hilary bashing > > > > > > > On Thu, 2003-06-12 at 16:42, Russell Scott wrote: > > > > I'm talking about Michael Savage, and his radio show "The

Savage

> > Nation". > > > > Also has a show on MSNBC on Saturday. Is that the same as

Savage

> Love? > > > > > > > > R > > > > > > Exactly the same! > > > > > > Why don't you see for yourself: > > > http://www.theonionavclub.com/savage.php?savage_id=24 > > > > > > And remember folks to clean up your santorum when you're done. > > > > > > Z > > > DC > > > A5X > > > A12X > > > > > > > >

[kdxkawboy@aol.com]

In a message dated 2003-06-14 1:47:26 PM Pacific Daylight Time, mah78@... writes:

> > I use the blue lock tite, I want them to stay put. The torque values > are not that high only 18 ft-lb. Did you use a small allen wrench? > Perhas they were tightened down to hard. You can pick up a 3/8 drive > socket that has the correct allen and is makes it much easier to > remove the caliper allens. > --Jim > > >I just replaced my brake pads and it was very difficult to break > >loose the allen screw holding the calipers on. My question is, > >should I use lock tite on them when I tighten them back up? > > > >Ken D > >Columbia River Gorge > >

I always use a little blue loctite on reassembly. I don't think its that uncommon for those allen screws to be a bit hard to get off with just an allen wrench - I use allen sockets on my 3/8 drive. I think over time the heat of the caliper 'sweats' them in place. Pat G'ville, Nv [Non-text portions of this message have been removed]