[dsn_klr650] bashing the moose

[Alan L Henderson]

At 03:28 PM 8/6/2000 -0700, you wrote:

>This is really a good question Mike. I'm now imagining an >insertable allen head type plug, magnetic of course, that's >flush with the bottom of the crankcase..........and two >1/4 square stock aluminum rails, running front to back, >welded to the underside of the plate on either side >of my drain plug hole........... >Toby > >Mike Awesome wrote: > >> I was doing some research and found an earlier post in which Mr.

Snip==== I used a hacksaw and cut off at least half of the lower part of the drain plug before I went to Moab this year. Will just have to be careful when removing due to the removal of half of the surface the socket bares on. Alan Henderson A13 Iowa