[dsn_klr650] higher wattage bulb

DSN_KLR650
Post Reply
Robert E. Faircloth, D.M.D.
Posts: 16
Joined: Thu Apr 20, 2000 8:27 am

[dsn_klr650] cdi trouble shooting

Post by Robert E. Faircloth, D.M.D. » Fri Jul 28, 2000 5:41 pm

Dash,   Sounds a lot like the CDI that died on me.  About half the readings were bad.  All 'bad' values were either open or in the 1-3 megohm range, with a digital meter.   Robert A13   ---- Original Message -----
I'll get an analog meter just to verify this.  However, I wasn't getting erratic results. I was getting very stable values, they were just way off from what the chart indicates. I also made a chart but I left mine at home this morning.  I'll take a break in a couple of hours and go get it.  Just to give you an example though, the entire chart calls for readings in the kohm range.  Much of my chart is in the MegOhm range and yet a few other cells of the chart are in the ohm range.  The only thing that was right on was the opens with the Bk/W wire.


Post Reply

Who is online

Users browsing this forum: No registered users and 21 guests