[dsn_klr650] questions: handguards

[Russell Scott]

This is what they say about them on their web site. They should work fine. Mounting Kits .While each of our guards come complete with all the mounting hardware neccessary to bolt right up to any standard aluminum or steel bar, we also offer special mounting kits to fit the Pro-Taper & PHS handlebars as well as replacement sets for the stock set-ups. Russel'r -----Original Message----- From: Dale Johnson Sent: Monday, May 22, 2000 8:43 AM To: DSN_klr650@egroups.com Subject: [DSN_klr650] Questions: Handguards I went to Chaparrel this weekend and got a new rear tire, its a Bridgestone, Not sure which one at this time but it looks better than the stock one without loosing the dirt capabilities. Soo anyway while I was there I saw a set of acerbis handguards and was wondering if anyone has installed them? Do they fit a KLR? and your opinion in general. They were the Rally DualSport Handguard with a blinker on the handguard. Since I shatered a rear blinker this weekend, I was thinking there is no better time to get this handguard, I can take off the fron blinkers and wire in the handguards Then replace the one I shatered in back with the one from the front. Comments? Suggestions? Dale 00 KLR650 with 5900 miles