nklr strings

[Alan L Henderson]

At 08:06 PM 4/18/2000 -0500, you wrote:

>>>>

Okay, I've been searching high and low for a torque wrench with a 1/4" drive that reads in inch/lbs so I can check/adjust valve clearance. I've had zero success with this Any shot that a person could use a 3/8" drive torque wrench and get 3/8 drive sockets? Would there be room to work still? Am I gonna be able to even find the metric sockets I need in 3/8 drive? Am I gonna need a prescription for lithium soon? going nuts.... ----------

[Skip Faulkner]

List,

   I want to apologize ahead of time for my future posts. I`ve been pretty much off-line, except for some quick snatches of posts, since we`ve been moving. Due to the fact that the area we now live has no phone service or electricity, my posts will be mostly done at night on my laptop and uploaded ( posted) the next day at work. What I am pre-apologizing for is that because of this, my posts will be in strings, sort of like Jeff used to do, and believe me, I`C got quite a few built up over the winter. Just fair warning.

 

Skip ( No TV means plenty of List time)