Carburetor overflow pipes.

[Robin Montgomery]

Can anyone give me the details of where to run the carburetor overflow pipes on a late TC? None of the pictures which I have found give sufficient detail. Do they pass in front of the engine bearer? Where is the clip (for the two pipes) secured?

It would be a bonus if you can tell me the length of each pipe.

 

Regards

 

Robin Montgomery

CT, USA

RMontgomery@doriandrake.com

 

[Norman Verona]

Robin,

 

Mine go down to the front engine mounting bolt and are held by a metal clip. Have a look at my blog for August or September and there may be a picture

 

 

[b][i]Norman Verona[/i][/b]

11 Cherry Close, Royston, South Yorkshire S71 4LZ

Phone: 0044 (0)1226 728811

Mob: 0044 (0)741 9905 741

[b][i]Web: www.frenchblat.com[/i][/b]

 

[b]From:[/b] mg-tabc@yahoogroups.com [mailto:mg-tabc@yahoogroups.com] [b]On Behalf Of [/b]Robin Montgomery RMontgomery@doriandrake.com [mg-tabc] [b]Sent:[/b] 30 September 2017 16:44 [b]To:[/b] mg-tabc@yahoogroups.com [b]Subject:[/b] [mg-tabc] Carburetor overflow pipes.

 

 

Can anyone give me the details of where to run the carburetor overflow pipes on a late TC? None of the pictures which I have found give sufficient detail. Do they pass in front of the engine bearer? Where is the clip (for the two pipes) secured?

It would be a bonus if you can tell me the length of each pipe.

 

Regards

 

Robin Montgomery

CT, USA

RMontgomery@doriandrake.com

 

[tim_jackson_tc0999]

Does this help?http://www.mg-cars.org.uk/imgytr/techni ... arburettor Overflow Pipe(s)

[Andrea VILLA]

Attachments :

[*][url=file:///C:\Users\Steve\AppData\Local\PG Offline 4\Attachments\\Shot2.jpeg]Shot2.jpeg[/url]

I can't give the pipe measurement My carbs have oldest short pipe strongly welded and I have prefered connect it by a plastic connection but from photo you can see the clip at the front over the engine support bar.it continue right to the sump attach- and are then gently curved to the rear