Re:

[Ray McCrary]

Rather depends on where you are located. In the US, gas varies State to State, and sometimes county to county in formulation. More moronics from the Feds, but there you go! Get a Colortune before leaning your mix. Best, Ray McCrary "Speed is Life; of course Luck and Altitude are helpful, too."

----- Original Message ----- [b]From:[/b] anngene@bellsouth.net [b]To:[/b] mg-tabc@yahoogroups.com [b]Sent:[/b] Monday, May 21, 2001 12:55 PM [b]Subject:[/b] [mg-tabc] A wee while ago someone in either this group or another (smile - trying to narrow it down) suggested that with today's gas formulations you could run the leaner needles in our carburetors. Would there be any advantage to doing this? Thanks, Gene Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/

David You can get the washers for the pedal shaft from C&C parts in Holland. [He is the fellow who sells also brake parts, cylinders etc.] Wiel Claessen Tel +31 77 477 2454 Fax +31 77 477 1676 PO Box 8350 AB Baarlo The Netherlands Mike ----- Original Message ----- [b]From:[/b] dairwin_2000@yahoo.com [b]To:[/b] mg-tabc@yahoogroups.com [b]Sent:[/b] Monday, May 21, 2001 11:08 AM [b]Subject:[/b] [mg-tabc] Thackery washers and track rod springs Dear all, Trying to track down a source (preferably a UK source) of two thackery washers (5/8" ID, 1" OD) for the pedal shafts. And a few springs that are found in the innards of the trackrod ends? I have tried B&G and MOSS UK without success (I was told they sell trackrods ends complete - made in USA). Any help much appreciated. DAI Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/

Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service.