soft luggage and racks

[psulsu8598]

Does anyone have any experience changing the mechanical seal for the water pump? How far should the seal be pushed into the case and how tightly and with type of instrument should you pound the other seal into the case, the seal with the aluminum case that goes over the mechanical seal and is pressed in by the impeller.

[don cain]

Uhmmmm, Could you post a pic?? Actually my G/F (yes guys she welds!!!) and I are thinking about building racks and brush guards for KLRs and a couple of other bikes. Going to prototype a luggage rack for the KLR first then build a jig from the proto.... I'll keep you guys posted when I get everything together.. -don On Thu, 31 Mar 2005 23:14:43 -0000, djhs4catsat404 wrote:

> > > Call me cheap but I made a rack that mounts directly over the rear > luggage rack. Three 1" by 1/4" by 48" flat steel bars is all that is > needed. ON the left side measure up 17" make a 90 degree angle, measure > over 13" and make an angle that puts the bar over the muffler and the > third angle will be straight down. You can tie the two together with > pieces made from the third piece of steel. I ran a brace directly under > the rear fender tying both sides together. The rack bolts directly over > the rear luggage rack using longer bolts. Cost, under $10. > > I have a set of Nashbar rear panniers that I use, the color matches my > 05 perfectly. > > Gary > > Archive Quicksearch at: http://www.angelfire.com/ut/moab/klr650_data_search.html > List sponsored by Dual Sport News at: www.dualsportnews.com > List FAQ courtesy of Chris Krok at: www.bigcee.com/klr650faq.html > > > Yahoo! Groups Links > > > > >