I was planning on replacing the thermostat in my KLR due to the fact
that it is running too cool. Also after a very long warm-up the
temperature swings wildly depending on if the bike is stoppped and
outside temp. This leads me to believe that the thermostat is stuck
open and not regulating the temp like it should. The first question
I have is, what is the proper sealant to use on the housing?
According to the microfiche, there is no gasket or seal indicated and
the parts counterman said to just use case sealant. Second, is there
a suitable aftermarket replacement for the thermostat? $29 for the
factory unit seems a bit pricey. Any advice would be greatly
appreciated.
Mark
another virus on the list/walmart
-
- Posts: 543
- Joined: Mon Apr 10, 2000 5:18 pm
another virus on the list/walmart
In a message dated 12/13/01 1:42:14 AM Eastern Standard Time,
monahanwb@... writes:
<< He may have picked something up over in Amsterdam......
Hey, Doesn't Wal-Mart -> SUCK? >>
Mine does, (thos bastards, bet they killed Kenny) this weekend, they were
out of thos 17.00 tank bags that I've been hearing so much about.
Scott
A14 "thunderdog"
Sorrento, Fl
Who is online
Users browsing this forum: No registered users and 24 guests