How small of an O ring do you need. Looking at my Napa assortment, they
go down to 1/8 ID -1/4 OD out of 1/16 stock. Have you talked to the gus
at your local parts store?
Don
KLR A13 "Salad Shooter"
73' TS185
[dsn_klr650] bashing the moose cont
-
- Posts: 1068
- Joined: Sat Apr 08, 2000 7:09 am
[dsn_klr650] o-ring help
Barry (BCDIRECT@...) wrote:
[fiddly little carby O-ring search]
Sounds like you need to go genuine. Mister_T> Does anyone have access to these two O-ring that could help me out?
-
- Posts: 70
- Joined: Tue Apr 11, 2000 6:12 pm
[dsn_klr650] bashing the moose cont
-----Original Message-----
From: Mike Awesome [mailto:mpasuit@...]
Sent: Sunday, August 06, 2000 12:10 PM
To: DSN_klr650@egroups.com
Subject: [DSN_klr650] bashing the moose cont
I surmise a log hit the bash
Mike Your drain plug must be below the plate. I was going to heli-arc a ridge on either side of the drain hole on my plate, but the nut doesn't protrude. I've dead centered lots of rocks without any problems. Maybe you can shim yours down on the drain hole end. Good luck DAngus A-11> plate which offered no protection for the drain plug. > Has anybody rigged something to protect the drain plug ? > > Mike very plugged Awesome > A1klr650
Who is online
Users browsing this forum: No registered users and 17 guests