hand guard - the simple aluminum bar type

[Weaver, Mark]

i'm going to put on my rally pro handguard tonight. the left side should be pretty straightforward, but are there any helpful hints for the right side? do i need to remove any of the actual throttle bits, or just cut a hole in the end of the grip? any special tools? -mark weaver

[Dale_Johnson@ahm.honda.com]

I bought an off brand aluminum bark buster at Malcom Smith Motorsprots in Riverside Ca. I bought the least expensive one I could find, $35 It was a tight squeeze, but i moved my clutch to the right a little and they fit good..( my break was missing the ball from an earlier crash) I did manage to heat up a stelleto and cut a hole in the stock guards and they fit perfect on the bark busters, I was amazed at how acurate my eye balling measurements were. Dale A14