[dsn_klr650] 95' klr oil leak

DSN_KLR650
Post Reply
zootpatutie
Posts: 336
Joined: Sun Apr 09, 2000 9:03 am

[dsn_klr650] 95' klr oil leak

Post by zootpatutie » Wed May 17, 2000 10:25 pm

Last year mine had a similar leak from the small bypass hole at the bottom of the housing which was oil bypassing the water pump shaft oil seal. Repair wasn't difficult, though it took me three tries and the bike being down for a month of great weather after being sold the wrong sized oil seal twice. Clean the area to see if this is the same for you. If so, and you choose to repair it, you'll need to replace the mechanical seal as well. Mine started leaking after a switch to synthetic oil and might have been liveable if I'd gone back to dino oil. Todd A9
----- Original Message ----- From: "Steve Rawls" To: DSN_klr650@egroups.com> Sent: Wednesday, May 17, 2000 5:02 PM Subject: [DSN_klr650] 95' KLR Oil Leak > question for me. I have a 95' KLR 650 that's sprung a leak.... It's not > a severe leak but an annoying one. I'm getting a constant drip/run of > oil from the oil filter/pump housing cover on the right side of the > bike. I've replaced the rubber O ring once and have even tried using a > silicon gasket sealer around the housing. Still leaks and I can't figure > out why. I checked for cracks and dings in the crank case housing and on > the cover it's self. Can't find any reason for the leak. It seems to > drip from the lip/nipple with the arrow on it. Anyone out there got any > ideas ?? Any and all info or suggestions will be greatly appreciated. > > Best Wishes, > > Steve Rawls >

Post Reply

Who is online

Users browsing this forum: No registered users and 19 guests