Betsy's tranmission noises
Posted: Wed Jan 12, 2000 10:11 pm
Carl,
Doesn't sound to me like Betsy's got any major problems with her
gearbox. I would leave it well alone unless I was pulling it out for
some other reason. If this was the case, I would do exactly what
has been recommended by the other guys with regard to bearings
etc.
In addition to the standard rattle from the gearshift. my TC2459 has
a gentle hum from the back axle at about 50 mph under no load
even after new bearings etc. so I just ignore it. However, the
standard differential bearings are not known for longevity so maybe
you should remove your diff centre section and check it out.
Perhaps you should also check the outer wheel bearings as well.
By the way, I've ordered tapered 1/2 shafts from Roger Furneaux for
both my TCs to eliminate certain worries from my life for ever (rear
wheel play, oil leaks broken shafts etc.). I realize that this will draw
remarks from my some of fans on the list but what the hell!
Viv James
Doesn't sound to me like Betsy's got any major problems with her
gearbox. I would leave it well alone unless I was pulling it out for
some other reason. If this was the case, I would do exactly what
has been recommended by the other guys with regard to bearings
etc.
In addition to the standard rattle from the gearshift. my TC2459 has
a gentle hum from the back axle at about 50 mph under no load
even after new bearings etc. so I just ignore it. However, the
standard differential bearings are not known for longevity so maybe
you should remove your diff centre section and check it out.
Perhaps you should also check the outer wheel bearings as well.
By the way, I've ordered tapered 1/2 shafts from Roger Furneaux for
both my TCs to eliminate certain worries from my life for ever (rear
wheel play, oil leaks broken shafts etc.). I realize that this will draw
remarks from my some of fans on the list but what the hell!
Viv James