Re: [MGSVW] Piston s wanted
Posted: Thu Sep 15, 2005 3:33 am
Carl;
When I needed pistons and rings for my VA I got them from Jahn's pistons in California. I gave them the measurements and they supplied all I needed.
Sandy Sanders
When I needed pistons and rings for my VA I got them from Jahn's pistons in California. I gave them the measurements and they supplied all I needed.
Sandy Sanders
----- Original Message -----
From: Carl Fritz
To: SVW Register ; SVW Group ; MG-TABC
Sent: Wednesday, September 14, 2005 9:27 PM
Subject: [MGSVW] Piston s wanted
I am in need of a set of 4 pistons and rings to suit, as follows:
Piston diameter 2.833 in. or 71.94 mm Oversize up to .060 in. also OK
Compression height (distance from center of wrist-pin/gudgeon-pin to piston crown) =1.69 in.
Wrist-pin/ Gudgeon-pin bore = 0.71 in.
Also need head gasket for MG VA with 72 mm cylinder bore (as in type TPDG engines offered for police use.)
Any leads/suggestions will be much appreciated.
Regards,
Carl Fritz
TC 6756 , VA 2009
Gainesville, Florida
email: carlmgtc@hotmail.com
SPONSORED LINKS Outdoor recreation Recreation vehicles Recreation jobs
Recreation jobs Recreation Car enthusiasts
------------------------------------------------------------------------------
YAHOO! GROUPS LINKS
a.. Visit your group "MGSVW" on the web.
b.. To unsubscribe from this group, send an email to:
MGSVW-unsubscribe@yahoogroups.com
c.. Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service.
------------------------------------------------------------------------------
[Non-text portions of this message have been removed]