Wilsons Sandbox

G'Day, Terry

Eventually, vintage folks get their act together!

If I recall, it was Jim Alcorn, the fellow with the superb VA Tickford
who got the rubber tool trays from Harvey Schnaer that he used to
make the molds. That is where I got mine, but that was late in the
last century. I believe that Jim has made more, but also, believe that
he sold the remainder to Barry Walker? Perhaps a call can confirm?

There was a thread on tabc where Roger Furneaux said on 30 August '04
that Ian Poole in the UK has also made the trays @ 85 pounds, but sold
the last of the lot to Barry Walker? Ian can be reached at: 01580 764 422
or poo@burren.fsbusiness.co.uk Maybe this is a source?

Hope this helps!

Had a great week with Gary Wall from NZ. The good doctor was most
kind and by ear and eye determined what shortcomings and problems
the TD, TC and TB were experiencing. Not only one fine and good fun
gentleman, but he is one knowledgeable fellow and sure keen on the M.G.,
of course, the SVW cars and the TA's.

Good luck, Mate!

from the Australia Room

Bill Hentzen
Mequon, in the Badger State

-----Urspr ngliche Nachricht-----
Von: mg-tabc@yahoogroups.com [mailto:mg-tabc@yahoogroups.com]Im Auftrag
von Bill Hentzen
Gesendet: Samstag, 27. August 2005 04:35
An: taterry@pacbell.net
Cc: mg-tabc
Betreff: [mg-tabc] Tool Trays-TA/B
Hi Bill,
One of my cousins is having a rubber factory making rubber mats in
India. If some one can arrange the old moulds it may be possible to make the
rubber tool trays. The price may depend on the complicity. I am sure they
will do me this favour. The moulds can be manufactured there. It is a lot of
work to make a new mould. If we can get the mould I hope it will never be
more than 10 for one. Or it may be much cheaper ? Have a look at the
products they make. We do have local latex as raw material available.

NARENDRAN GROUP
INDUSTRIES,PLANTATION,RESORTS
ANVIL,KADAPPAKADA,KOLLAM-691008
KERALA,INDIA.
TEL:91 474 2742491,2749341,2744907
FAX:91 474 2744069,2740647.
e-mail : topfloor@vsnl.com
WEB : www.topflor.com


Best regards

Madhu






G'Day, Terry

Eventually, vintage folks get their act together!

If I recall, it was Jim Alcorn, the fellow with the superb VA Tickford
who got the rubber tool trays from Harvey Schnaer that he used to
make the molds. That is where I got mine, but that was late in the
last century. I believe that Jim has made more, but also, believe that
he sold the remainder to Barry Walker? Perhaps a call can confirm?

There was a thread on tabc where Roger Furneaux said on 30 August '04
that Ian Poole in the UK has also made the trays @ 85 pounds, but sold
the last of the lot to Barry Walker? Ian can be reached at: 01580 764 422
or poo@burren.fsbusiness.co.uk Maybe this is a source?

Hope this helps!

Had a great week with Gary Wall from NZ. The good doctor was most
kind and by ear and eye determined what shortcomings and problems
the TD, TC and TB were experiencing. Not only one fine and good fun
gentleman, but he is one knowledgeable fellow and sure keen on the M.G.,
of course, the SVW cars and the TA's.

Good luck, Mate!

from the Australia Room

Bill Hentzen
Mequon, in the Badger State





Yahoo! Groups Links