Page 1 of 1

BC steering box rubber anti-rattle ring

Posted: Tue Aug 16, 2005 5:57 am
by John Pavone
Moss lists a rubber anti-rattle ring (part #262-320), which according to their illustration, goes around the inner steering column shaft. What's the purpose of this part and is it really needed? Since my BC box has been rebuilt and is ready to go back in the car, I'd really hate to have to disassemble it again, to install this ring. Thanks. JP TC2797

Re: BC steering box rubber anti-rattle ring

Posted: Tue Aug 16, 2005 7:12 am
by Chip Old
On Tue, 16 Aug 2005 12:57 -0000, John Pavone wrote:
> Moss lists a rubber anti-rattle ring (part #262-320), which according to > their illustration, goes around the inner steering column shaft. What's > the purpose of this part and is it really needed? > > Since my BC box has been rebuilt and is ready to go back in the car, I'd > really hate to have to disassemble it again, to install this ring.
It prevents the relatively limber inner column from vibrating against the inside of the outer column. Omitting it doesn't effect how the steering gear works, it just stops it from rattling. Unless you drive a lot on rough roads, yours may never rattle. -- Chip Old 1948 M.G. TC Cub Hill, Maryland, US TC6710 XPAG7430 fold@bcpl.net NEMGTR #2271

Re: BC steering box rubber anti-rattle ring

Posted: Tue Aug 16, 2005 7:26 am
by Pavone, John (Corporate)
The roads around here are pretty decent, so I'll leave it out. Thanks! JP TC2797
>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>
Chip Old wrote: It prevents the relatively limber inner column from vibrating against the inside of the outer column. Omitting it doesn't effect how the steering gear works, it just stops it from rattling. Unless you drive a lot on rough roads, yours may never rattle. -- Chip Old 1948 M.G. TC Cub Hill, Maryland, US TC6710 XPAG7430 fold@bcpl.net NEMGTR #2271 Yahoo! Groups Links

Re: BC steering box rubber anti-rattle ring

Posted: Tue Aug 16, 2005 4:42 pm
by Larry & Marilyn
Hi John A couple of hose bib washers will work just fine. Larry TC 4703

Re: BC steering box rubber anti-rattle ring

Posted: Wed Aug 17, 2005 9:19 am
by Gordon Bruce Lawson
Not sure if it is the same, however, the TD has a felt bushing at the top and bottom of the steering shaft... one of mine is loose and the rattle of the inner and outer shaft drives me crazy... Doesn't rattle when driving straight but on turns it is annoying. If you end up with the rattle, you will strip it all down again. At 4:43 AM +0000 8/17/05, mg-tabc@yahoogroups.com wrote:
>Moss lists a rubber anti-rattle ring (part #262-320), which according >to their illustration, goes around the inner steering column shaft. >What's the purpose of this part and is it really needed? > >Since my BC box has been rebuilt and is ready to go back in the car, >I'd really hate to have to disassemble it again, to install this ring. > >Thanks. > >JP > >TC2797
-- Gordon Lawson 1953 MG TD http://www3.sympatico.ca/gordonblawson/td/td.html MG-T Data Base: http://www.niagarabritishcarclub.org/mgtnumbers/numbers.html