Page 1 of 1
TC clatter - Engine Noises
Posted: Thu May 12, 2005 4:55 pm
by BDavis
Fellows...
I may be preaching to to choir here but I've been able to find most of
my 'funny' engine noises using a short (4') section of garden hose.
Obviously you can't listen to everything while driving at speed... but
most 'unusual noises' can be located using a hose while the car is
stationary.
One of the most basic things you can do for your engine's health is
listen to all the moving parts while it is healthy. You might not
remember just exactly what something is supposed to sound like when it
goes off but at least you've heard what it Should be sounding like.
Hold one end of the garden hose to/in your ear and then 'play' the
other end over/around/near the moving parts... Like the front and back
of the generator or the water pump, the distributor or valve train etc.
Another method is to use a long metal rod. This one is particularly
good for listening to the lower end of the engine. Place one end of the
rod on the bone behind your ear and the other end on the lower part of
the block. By moving forward and backward on the block -down near where
the crank is turning- will allow you to hear more clearly what the rods
and mains are up to.
Vary the engine speed with both methods!
Placing either the hose or the rod into the rotating fan blades adds
considerable excitement to the experiment.... and is NOT advised!
That's my 2 cents worth.
B Davis - Nashville
__________________________________
Yahoo! Mail Mobile
Take Yahoo! Mail with you! Check email on your mobile phone.
http://mobile.yahoo.com/learn/mail
Re: TC clatter - Engine Noises
Posted: Thu May 12, 2005 6:10 pm
by 1939mgtb
Absolutely!! It is a good old trick that works like a stethoscope.
Best,
Ray
"Morology is our profession,
our ONLY profession!"
----- Original Message -----
From: "BDavis" bdavispics@yahoo.com>
To: mg-tabc@yahoogroups.com>
Sent: Thursday, May 12, 2005 6:55 PM
Subject: [mg-tabc] TC clatter - Engine Noises
> Fellows...
> I may be preaching to to choir here but I've been able to find most of
> my 'funny' engine noises using a short (4') section of garden hose.
> Obviously you can't listen to everything while driving at speed... but
> most 'unusual noises' can be located using a hose while the car is
> stationary.
>
> One of the most basic things you can do for your engine's health is
> listen to all the moving parts while it is healthy. You might not
> remember just exactly what something is supposed to sound like when it
> goes off but at least you've heard what it Should be sounding like.
>
> Hold one end of the garden hose to/in your ear and then 'play' the
> other end over/around/near the moving parts... Like the front and back
> of the generator or the water pump, the distributor or valve train etc.
>
> Another method is to use a long metal rod. This one is particularly
> good for listening to the lower end of the engine. Place one end of the
> rod on the bone behind your ear and the other end on the lower part of
> the block. By moving forward and backward on the block -down near where
> the crank is turning- will allow you to hear more clearly what the rods
> and mains are up to.
>
> Vary the engine speed with both methods!
>
> Placing either the hose or the rod into the rotating fan blades adds
> considerable excitement to the experiment.... and is NOT advised!
>
> That's my 2 cents worth.
>
> B Davis - Nashville
>
>
>
> __________________________________
> Yahoo! Mail Mobile
> Take Yahoo! Mail with you! Check email on your mobile phone.
>
http://mobile.yahoo.com/learn/mail
>
>
>
> Yahoo! Groups Links
>
>
>
>
>
>
Re: TC clatter - Engine Noises
Posted: Thu May 12, 2005 6:18 pm
by 1939mgtb
**I may be preaching to choir here but I've been able to find most of
> my 'funny' engine noises using a short (4') section of garden hose.
My cars have so many funny noises, I got them a part in a band......"The
Rolling Steel Bluegrass Cacophony"!
Best,
Ray
Re: TC clatter - Engine Noises
Posted: Fri May 13, 2005 6:04 pm
by kwcp
Any auto parts store should have a mechanics stethoscope for about 5
bucks. You will wonder how you ever got along without it.
Ken Porter TC 4147 Manchester NH
1939mgtb wrote:
>Absolutely!! It is a good old trick that works like a stethoscope.
>Best,
>Ray
>"Morology is our profession,
>our ONLY profession!"
>----- Original Message -----
>From: "BDavis" bdavispics@yahoo.com>
>To: mg-tabc@yahoogroups.com>
>Sent: Thursday, May 12, 2005 6:55 PM
>Subject: [mg-tabc] TC clatter - Engine Noises
>
>
>
>
>>Fellows...
>>I may be preaching to to choir here but I've been able to find most of
>>my 'funny' engine noises using a short (4') section of garden hose.
>>Obviously you can't listen to everything while driving at speed... but
>>most 'unusual noises' can be located using a hose while the car is
>>stationary.
>>
>>One of the most basic things you can do for your engine's health is
>>listen to all the moving parts while it is healthy. You might not
>>remember just exactly what something is supposed to sound like when it
>>goes off but at least you've heard what it Should be sounding like.
>>
>>Hold one end of the garden hose to/in your ear and then 'play' the
>>other end over/around/near the moving parts... Like the front and back
>>of the generator or the water pump, the distributor or valve train etc.
>>
>>Another method is to use a long metal rod. This one is particularly
>>good for listening to the lower end of the engine. Place one end of the
>>rod on the bone behind your ear and the other end on the lower part of
>>the block. By moving forward and backward on the block -down near where
>>the crank is turning- will allow you to hear more clearly what the rods
>>and mains are up to.
>>
>>Vary the engine speed with both methods!
>>
>>Placing either the hose or the rod into the rotating fan blades adds
>>considerable excitement to the experiment.... and is NOT advised!
>>
>>That's my 2 cents worth.
>>
>>B Davis - Nashville
>>
>>
>>
>>__________________________________
>>Yahoo! Mail Mobile
>>Take Yahoo! Mail with you! Check email on your mobile phone.
>>
http://mobile.yahoo.com/learn/mail
>>
>>
>>
>>Yahoo! Groups Links
>>
>>
>>
>>
>>
>>
>>
>>
>
>
>
>Yahoo! Groups Links
>
>
>
>
>
>
>
>
>
[Non-text portions of this message have been removed]
Re: TC clatter - Engine Noises
Posted: Fri May 13, 2005 10:18 pm
by 1939mgtb
Or a piece of rubber hose for a buck....
Best,
Ray
"Morology is our profession,
our ONLY profession!"
----- Original Message -----
From: kwcp
To: 1939mgtb
Cc:
mg-tabc@yahoogroups.com ; BDavis
Sent: Friday, May 13, 2005 8:04 PM
Subject: Re: [mg-tabc] TC clatter - Engine Noises
Any auto parts store should have a mechanics stethoscope for about 5 bucks. You will wonder how you ever got along without it.
Ken Porter TC 4147 Manchester NH
1939mgtb wrote:
Absolutely!! It is a good old trick that works like a stethoscope.
Best,
Ray
"Morology is our profession,
our ONLY profession!"
----- Original Message -----
From: "BDavis" bdavispics@yahoo.com>
To: mg-tabc@yahoogroups.com>
Sent: Thursday, May 12, 2005 6:55 PM
Subject: [mg-tabc] TC clatter - Engine Noises
Fellows...
I may be preaching to to choir here but I've been able to find most of
my 'funny' engine noises using a short (4') section of garden hose.
Obviously you can't listen to everything while driving at speed... but
most 'unusual noises' can be located using a hose while the car is
stationary.
One of the most basic things you can do for your engine's health is
listen to all the moving parts while it is healthy. You might not
remember just exactly what something is supposed to sound like when it
goes off but at least you've heard what it Should be sounding like.
Hold one end of the garden hose to/in your ear and then 'play' the
other end over/around/near the moving parts... Like the front and back
of the generator or the water pump, the distributor or valve train etc.
Another method is to use a long metal rod. This one is particularly
good for listening to the lower end of the engine. Place one end of the
rod on the bone behind your ear and the other end on the lower part of
the block. By moving forward and backward on the block -down near where
the crank is turning- will allow you to hear more clearly what the rods
and mains are up to.
Vary the engine speed with both methods!
Placing either the hose or the rod into the rotating fan blades adds
considerable excitement to the experiment.... and is NOT advised!
That's my 2 cents worth.
B Davis - Nashville
__________________________________
Yahoo! Mail Mobile
Take Yahoo! Mail with you! Check email on your mobile phone.
http://mobile.yahoo.com/learn/mail
Yahoo! Groups Links
Yahoo! Groups Links
[Non-text portions of this message have been removed]