Page 1 of 1
XPEG Engine block
Posted: Thu May 12, 2005 10:34 am
by davjak@aol.com
Andy,
Could the block (with a few mods) be made out of Aluminum? With all of the
advancements in engines, this would be quite sweet without the weight.. Where
do I send the check?
Dave
TC x 3 (one needs a XPEG 1500)
[Non-text portions of this message have been removed]
Re: XPEG Engine block
Posted: Thu May 12, 2005 1:31 pm
by Joe Gates
Interesting. An ali block attached to a T-Type front end might give new
meaning to a "floating square rigger"?!
Joe
Dave wrote
> Could the block (with a few mods) be made out of Aluminum? With all of the
> advancements in engines, this would be quite sweet without the weight.