pins or dowels

[TMcNam4510@aol.com]

There are 2 dowels that thread into the rear of the engine, I assume to locate the bell housing. They are about 1 1/2 inches apart. On TC 2850 one is broken off. I don't find them in the Moss or A/S books. Does anyone know the part number or supplier? Thanks Tom [Non-text portions of this message have been removed]

[Gene Gillam]

Tom asked:

>There are 2 dowels that thread into the rear of the engine, I assume to

locate the bell housing. They are about 1 1/2 inches apart. On TC 2850 one is broken off. I don't find them in the Moss or A/S books. http://www.mossmotors.com/Shop/ViewProducts.aspx?PlateIndexID=32714#148 Believe that that is Moss Part Number 325-318 . Best, Gene Gillam Saucier, MS -- No virus found in this outgoing message. Checked by AVG Anti-Virus. Version: 7.0.308 / Virus Database: 266.10.2 - Release Date: 4/21/2005

[ian thomson]

Normally such things are easy to make. Just cut the head off a bolt; turning the shank down a bit if necessary. Ian Thomson. -------- --- TMcNam4510@aol.com wrote:

> > There are 2 dowels that thread into the rear of the > engine, I assume to > locate the bell housing. They are about 1 1/2 > inches apart. On TC 2850 one is > broken off. I don't find them in the Moss or A/S > books. Does anyone know the > part number or supplier? Thanks Tom > > > [Non-text portions of this message have been > removed] > > > > > Yahoo! Groups Links > > > mg-tabc-unsubscribe@yahoogroups.com > > > > > >

Send instant messages to your online friends http://uk.messenger.yahoo.com