Wilsons Sandbox

Two 1/4" BSF bolts, front one goes through fender brace, steel pad, pad rubber, fender, light pad rubber, light and screws into the inner light socket base. Approx length 1", maybe a bit less. Rear bolt goes through steel pad, pad rubber, fender, light rubber, light and screws into light socket base. Length about 3/4" or less. Bob Bob Grunau 150 Pinewood Trail, Mississauga, Ontario, Canada, L5G-2L1 905-274-4136 -----Original Message----- From: Peter Lund, MD [mailto:Pgl@prodigy.net] Sent: Tuesday, March 08, 2005 2:32 PM To: mg-tabc@yahoogroups.com Subject: [mg-tabc] Screw/bolt for front wing lights. Some where in time, someone attached my front wing lights to the fender with large screws. They are so large that the extra length is taken up by a 1/4 inch nut used as a spacer washer. I can't find these on any original drawings. Can somebody tell me how the front wing light should be fastened to the fender. Screw or Bolt, size and lenght. Pete Lund --------------------------------- Celebrate Yahoo!'s 10th Birthday! Yahoo! Netrospective: 100 Moments of the Web [Non-text portions of this message have been removed] Yahoo! Groups Links