Wilsons Sandbox

#ygrps-yiv-153202159 P {margin-top:0;margin-bottom:0;} [b]From:[/b] Richard [b]Sent:[/b] 02 August 2019 09:19 [b]To:[/b] mg-tabc-noreply@yahoogroups.com mg-tabc-noreply@yahoogroups.com> [b]Subject:[/b] TC suspension spring clamps   Hello  Undertaking the front and rear suspension rebuilds, early '46 TC.  Do the lower/bottom spring clamp plates, the ones with four 5/16 bsf studs protruding have reinforcing plates?  The parts lists (Moss, NTG, Doug etc) mentions 4 of them, but nearly all TCs veiwed in UK don't!  Except one Aussie import with one, 2 hole plate either side rear. Where are the 4 to go? What is correct please? Regards  Richard Evans  

Richard, There are 2 ea reinforcing plates on under each front spring mounting bracket for a total of 4 (left and right sides)...if I understood your question correctly. Gene Gillam Saucier, MS Sent from my iPad

On Aug 2, 2019, at 12:33 PM, Richard rev.rem@hotmail.com [mg-tabc] mg-tabc-noreply@yahoogroups.com> wrote:

  [b]From:[/b] Richard [b]Sent:[/b] 02 August 2019 09:19 [b]To:[/b] mg-tabc-noreply@yahoogroups.com mg-tabc-noreply@yahoogroups.com> [b]Subject:[/b] TC suspension spring clamps   Hello  Undertaking the front and rear suspension rebuilds, early '46 TC.  Do the lower/bottom spring clamp plates, the ones with four 5/16 bsf studs protruding have reinforcing plates?  The parts lists (Moss, NTG, Doug etc) mentions 4 of them, but nearly all TCs veiwed in UK don't!  Except one Aussie import with one, 2 hole plate either side rear. Where are the 4 to go? What is correct please? Regards  Richard Evans