Page 1 of 1
HOLE IN CENTER OF ENGINE MOUNT BRACKET.
Posted: Thu Jun 20, 2019 2:18 pm
by Carlyle Merritt
Did the MGTA engine bracket not have a rebound rubber? All rebound
rubbers have a
center rubber of 1 3/32 inch and my engine mount brackets for the TA
have a 3/4 inch hole
in the bracket. Maybe the TA lacked a rebound rubber? I could drill
that hole to fit the rebound
rubbers.
Re: HOLE IN CENTER OF ENGINE MOUNT BRACKET.
Posted: Thu Jun 20, 2019 4:04 pm
by Clive Sherriff
Carlyle,
The rebound rubber (S118/9) and associated bits, was introduced with the TB TB251 on. See MG TA TB Service Parts List, page 49.
Makes sense to retro fit to the TAs though.
CliveOxford, UK
On Thu, 20 Jun 2019 at 22:22, Carlyle Merritt
carlyle@merritt-computer.com [mg-tabc] mg-tabc-noreply@yahoogroups.com> wrote:
[u][/u]
Did the MGTA engine bracket not have a rebound rubber? All rebound
rubbers have a
center rubber of 1 3/32 inch and my engine mount brackets for the TA
have a 3/4 inch hole
in the bracket. Maybe the TA lacked a rebound rubber? I could drill
that hole to fit the rebound
rubbers.