Attachments :
[*][url=file:///C:\Users\Steve\AppData\Local\PG Offline 4\Attachments\\T-type door.pdf]T-type door.pdf[/url]
[b]From:[/b] John Boocock [mailto:
johnboocock2@gmail.com]
[b]Sent:[/b] 01 May 2019 09:42
[b]To:[/b] '
grunau.garage@sympatico.ca'
[b]Subject:[/b] RE: [mg-tabc] Door handle position question Hi Bob,Thanks, it does indeed make you a kind person.The sketch attached shows the reference I was after. Please excuse my drawing, I am a little out of practice and MS paint does not seem to be what it used to be.Does this change any of your figures for the dimension A?How do the dimensions B compare please?Many thanks,John [b]From:[/b]
mg-tabc@yahoogroups.com [mailto:
mg-tabc@yahoogroups.com] [b]On Behalf Of [/b]'Bob Grunau'
grunau.garage@sympatico.ca [mg-tabc]
[b]Sent:[/b] 30 April 2019 22:41
[b]To:[/b]
johnboocock2@gmail.com;
mg-tabc@yahoogroups.com
[b]Subject:[/b] RE: [mg-tabc] Door handle position question Hi John,,I found the following: TA0652, 1936, center of door handle to peak of door where it meets scuttlle peak = 10-1/4 , both sides.I have other doors, but not sure if TA/TB or TC. Red TC= 9-1/2 Black TC= 9-1/2 Sequoia TC= 9-1/2 So looks like TC door handle location is is about higher for the door handle than the TA, I could not quite figure out your reference perpendicular line?? Does this make me a kind person ?? Bob Bob Grunau150 Pinewood Trail,Mississauga, OntarioCanada, L5G-2L1905-274-4136 [b]From:[/b]
mg-tabc@yahoogroups.com [mailto:
mg-tabc@yahoogroups.com] [b]On Behalf Of [/b]
johnboocock2@gmail.com [mg-tabc]
[b]Sent:[/b] Tuesday, April 30, 2019 10:42 AM
[b]To:[/b]
mg-tabc@yahoogroups.com
[b]Subject:[/b] [mg-tabc] Door handle position question
Dear group members,
I am in the position of needing to make/convert a TC door as I find I have one TC door and one TA door. Before proceeding with this I need to check that my TC door is in fact correct. Please could someone check the position of their outer TC door handle with reference to a line perpendicular to the front edge of the door and passing through the centre of the handle. I have several TA doors and the door handles are 10" from the highest point of the door (where it meets the dash).
I have only one TC door and the handle is 9" from the highest point of the door.
The maximum height of the TC door, at 19.75", also appears to be 0.5" less than the TA doors.
Could some kind person with both a TA and TC please confirm these figures for me?
[img]https://ec.yimg.com/ec?url=https%3A%2F%2Fipmcdn.avast.com%2Fimages%2Ficons%2Ficon-envelope-tick-round-orange-animated-no-repeat-v1.gif&t=1557435474&sig=70KSVRUuY_QqD0brHMTSug--~D[/img] Virus-free.
www.avast.com