Re: Hi! - (rear hub nut socket)

[mgtc3452]

Sorry for the late reply - just getting to my mail after a week out. As to the old style bearing nut, I took one of the nuts to the auto store and finally matched it up with a socket for a '86 Ford Bronco 4WD (it's for the front hubs on the Bronco). Get the one with the 4 tangs protruding from the opening, not the socket with the recessed tangs as this one will not fit over the nut. Anyway, it is a perfect fit and you can use it with a torque wrench (1/2 inch drive) to put the nut back on according to specs. VR - Terry V.P.

--- In mg-tabc@y..., Tombutlercpa@c... wrote: > > I'm Back. > > .> > Who sells a socket to remove the old style rear axle bearing nut? You know, > the one with recessed edges. .> > I find the recommendations to turn this nut with a chisel to be crude. > > Do I have a commercial opportunity here? > > Any better suggestions? > > > > > [Non-text portions of this message have been removed]