Virus Warning Thank-you

[tamata i valu]

Good-day all : I also have had strange messages and thanks to those early warnings I did not open any . The ones # 3 and # 4 listed by Mr. Hara were two that I received today as well ! Thanks again to the ever vigilant members of the " Group " , that have brought these menaces to light ! I should now like to make an enquiry . On Page # 77 of the Moss Catalogue # MGT 0204 , listed as item # 7 , Part # 190-295 , Release Bearing , Roller Bearing Type. I would like to know , from the membership , as to what , if any , the advantages are of employing this part rather than the conventional one , Part # 190-290 ? My mechanical skills are passable , but my engineering savy is sadly lacking . Cheers to all ; respectfully : Jack Emdall , TC # 6768

[i.thomson@talk21.com]

FWIW. Although my inbuilt conventional wisdom tends to feel that a roller release bearing would be better than the carbon one (less friction and does not break up) experience on other sites (esp the V8 site which I frequent) says otherwise. Apparently the roller bearing wears badly and thus becomes noisy, whereas the carbon bearing has to break up completely before it does this. Ian Thomson.

>On Page # 77 of the Moss Catalogue # MGT 0204 , listed as item # 7 , Part # >190-295 , Release Bearing , Roller Bearing Type. I would like to know , >from the membership , as to what , if any , the advantages are of employing >this part rather than the conventional one , Part # 190-290 ? My mechanical >skills are passable , but my engineering savy is sadly lacking . > >Cheers to all ; respectfully : Jack Emdall , TC # 6768 > > > > >Your use of Yahoo! Groups is subject to http://talk21.btopenworld.com/redirect.html?http://talk21.btopenworld.com/redirect.html?http://docs.yahoo.com/info/terms/''>[url=http://talk21.btopenworld.com/redirect.html?http://docs.yahoo.com/info/terms/'http://talk21.btopenworld.com/redirect.html?http://docs.yahoo.com/info/terms/'>>http://talk21.btopenworld.com/redirect.html?http://docs.yahoo.com/info/terms/'>[url=http://docs.yahoo.com/info/terms/http://docs.yahoo.com/info/terms/>

-------------------- talk21 your FREE portable and private address on the net at http://www.talk21.com

[Skip Kelsey]

Jack: DONT use the roller bearing Throwout. Skip................................... At 10:08 PM 4/17/02 -0700, tamata i valu wrote:

>Good-day all : > >I also have had strange messages and thanks to those early warnings I did >not open any . The ones # 3 and # 4 listed by Mr. Hara were two that I >received today >as well ! > >Thanks again to the ever vigilant members of the " Group " , that have >brought these menaces to light ! > >I should now like to make an enquiry . > >On Page # 77 of the Moss Catalogue # MGT 0204 , listed as item # 7 , Part # >190-295 , Release Bearing , Roller Bearing Type. I would like to know , >from the membership , as to what , if any , the advantages are of employing >this part rather than the conventional one , Part # 190-290 ? My mechanical >skills are passable , but my engineering savy is sadly lacking . > >Cheers to all ; respectfully : Jack Emdall , TC # 6768 > > > > >Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/