Page 1 of 1
Windshield Seal
Posted: Mon Apr 15, 2002 5:30 pm
by MGTDFL@aol.com
I have asked this question on the MGTD site but I haven't received an answer so I will ask it here.
I am trying to replace the seal around the windshield glass (Moss #280-300). How do I fit/position the seal over the wiper spacers that are in the glass slot? The PO did not use the correct seal and the spacers were rubbing directly on the glass. I think there should be some protection so the glass won't break. I am guessing that the TC is the same as it uses the same seal listed in the Moss Catalog.
Don
TD #17700
Re: Windshield Seal
Posted: Mon Apr 15, 2002 6:03 pm
by Sam Suklis
[b]I sort of recall the holes in the windshield frame for the wipers are well above the slot for the seal. Am I remembering this right? It's been a couple of years since I last did one of those. [/b] [b][/b] [b]Best regards, Sam Suklis[/b] [b]
SS[/b]
----- Original Message ----- [b]From:[/b]
MGTDFL@aol.com [b]To:[/b]
mg-tabc@egroups.com [b]Sent:[/b] Monday, April 15, 2002 5:30 PM [b]Subject:[/b] [mg-tabc] Windshield Seal
I have asked this question on the MGTD site but I haven't received an answer so I will ask it here.
I am trying to replace the seal around the windshield glass (Moss #280-300). How do I fit/position the seal over the wiper spacers that are in the glass slot? The PO did not use the correct seal and the spacers were rubbing directly on the glass. I think there should be some protection so the glass won't break. I am guessing that the TC is the same as it uses the same seal listed in the Moss Catalog.
Don
TD #17700
Your use of Yahoo! Groups is subject to the
Yahoo! Terms of Service.