Page 1 of 1
Trunnion housing
Posted: Wed Apr 03, 2002 5:25 am
by R.F.Butson
Has anyone out there repaired a worn front spring trunnion housing? if so what proceedure is recommended? Mine are worn around the contact surface with the bronze bushes and the spring entrance hole.The entrance hole itself I realise is not so important but the wear extends inwards and has cut into the sholder containing the lower fixing bolt hole...Bob.
Re: Trunnion housing
Posted: Wed Apr 03, 2002 8:25 am
by John G. Bulcken IV
I had mine sleeved...a good machine shop can do this. If you want a referral let me know off list. John
----- Original Message ----- [b]From:[/b]
robbut@onetel.net.uk [b]To:[/b]
mg-tabc@yahoogroups.com [b]Sent:[/b] Wednesday, April 03, 2002 7:55 AM [b]Subject:[/b] [mg-tabc] Trunnion housing
Has anyone out there repaired a worn front spring trunnion housing? if so what proceedure is recommended? Mine are worn around the contact surface with the bronze bushes and the spring entrance hole.The entrance hole itself I realise is not so important but the wear extends inwards and has cut into the sholder containing the lower fixing bolt hole...Bob.
Your use of Yahoo! Groups is subject to the
Yahoo! Terms of Service.