Page 1 of 1
Bolts and nuts in Dallas / Forth Worth
Posted: Mon Mar 11, 2002 12:49 am
by Peter Forstner
Hi friends,
I'm from Germany, but will be on a business trip in Dallas / Forth Worth area for the next two weeks. I'm searching some odd bolts and nuts which should be UNC/UNF. Is there a good shop for bolts and nuts in DFW? Where is it?
I'll read my e-mail also in Dallas.
Best regards (still form Germany)
Peter Forstner - TC6325
Re: Bolts and nuts in Dallas / Forth Worth
Posted: Mon Mar 11, 2002 6:50 am
by Frank O_ The Mountain
In a message dated 3/11/02 00:50:31 Pacific Standard Time,
peter@mg-tc.de
writes:
>
Speaking of bolts and nuts in DFW, there is an article on the restoration of
a Triumph Gloria in DFW and the owner mentions that he used a lot of s/s nuts
and bolts from a shop in Dallas. These must have been BSF. Does anyone know
the shop?
Tnx
Terry
Re: Bolts and nuts in Dallas / Forth Worth
Posted: Mon Mar 11, 2002 7:13 am
by candahill@worldnet.att.net
Metric & Multistandard Component Corp has an office in
Dallas. Check out
www.metricmcc.com/metric.htm.
Regards,
Charles Hill
Re: Bolts and nuts in Dallas / Forth Worth
Posted: Mon Mar 11, 2002 12:02 pm
by WinEstes@aol.com
In a message dated 3/11/2002 00:50:21 Pacific Standard Time,
peter@mg-tc.de writes:
I'm searching some odd bolts and nuts which should be UNC/UNF.
From my reading of this, Peter is looking for standard SAE (NC & NF) fasteners. If this is the case, than any hardware store for NC and any NAPA-type auto parts store for NF.
Win Estes