Page 1 of 1
TABC FRONT AXLE
Posted: Sun Feb 17, 2002 2:44 pm
by DAVID DARRELL
Hi is anybody interested in
new front axle beams all machined and ready to fit. Approx cost 350 excluding taxes and carriage. If enough people are interested then the price could be lower. Stub axles in modern steel are next price approx 150 BRITISH POUNDS but the company must know approx how many are required. They are also interested in making other cast steel components such as brake and clutch pedals and the petrol tank strap fixings (normally in cast iron which breaks) but will only do so if there are enough people interested to spread the cost of the patterns etc. email them at
mgta@morrisgarages.co.uk with your interests
Re: TABC FRONT AXLE
Posted: Mon Feb 18, 2002 2:25 am
by DAVID DARRELL
[b]
Sorry everone interested i got the email address wrong it should be mgta@merlingarages.co.uk (thinking too much about MGs)[/b]
----- Original Message ----- [b]From:[/b]
DAVID@ddarrell.freeserve.co.uk [b]To:[/b]
mg-tabc@yahoogroups.com [b]Sent:[/b] Sunday, February 17, 2002 10:47 PM [b]Subject:[/b] [mg-tabc] TABC FRONT AXLE
Hi is anybody interested in
new front axle beams all machined and ready to fit. Approx cost 350 excluding taxes and carriage. If enough people are interested then the price could be lower. Stub axles in modern steel are next price approx 150 BRITISH POUNDS but the company must know approx how many are required. They are also interested in making other cast steel components such as brake and clutch pedals and the petrol tank strap fixings (normally in cast iron which breaks) but will only do so if there are enough people interested to spread the cost of the patterns etc. email them at
mgta@morrisgarages.co.uk with your interests
Your use of Yahoo! Groups is subject to the
Yahoo! Terms of Service.
Re: TABC FRONT AXLE
Posted: Tue Feb 19, 2002 10:06 am
by Peter Pleitner
Hi David, I might be interested and notified MorrisGarages. Thank you. To the group I have a question on this subject. If an axle were reproduced would it be advantageous to request less or zero positive camber? I'd be interested in a thread on this subject, especially proposed specs for standard tires and wheels, and modern road conditions. Cheers, Peter [quote] -----Original Message-----
[b]From:[/b] DAVID DARRELL [mailto:
DAVID@ddarrell.freeserve.co.uk]
[b]Sent:[/b] Sunday, February 17, 2002 5:47 PM
[b]To:[/b]
mg-tabc@yahoogroups.com
[b]Subject:[/b] [mg-tabc] TABC FRONT AXLE
Hi is anybody interested in
new front axle beams all machined and ready to fit. Approx cost 350 excluding taxes and carriage. If enough people are interested then the price could be lower. email them at
mgta@morrisgarages.co.uk with your interests
[/quote]