sidescreen fasteners and color
Posted: Thu Feb 07, 2002 5:27 pm
Good evening, folks,
In 1980, when I did the bows and screen frames for a 51TD, I took a piece
with the paint reasonably intact and read the color in the color computer at
work{ Industrial Paint Mfgr} and made a two component epoxy to match. Have
used on two TC bow and side screen set since.
If anyone is interested in a color chip of this nondescript beige, I'll
spray one out for you when I touchup the frames on the current TC in about
4-6 weeks.
All the frames had the curved head sliding T bolts and hex nuts. The nuts
seem to be a smaller cross section and lower in height then the typical
2BA.
Cheers!
Bill