Re: Copper to 30 Zinc - used for cartridge
Posted: Sun Oct 14, 2001 6:02 am
----- Original Message ----- From: "Fred Kuntz" fredkuntz@ncweb.com> To: cgrunau@pathcom.com> Sent: Sunday, October 14, 2001 8:49 AM Subject: Re: [mg-tabc] Copper to 30 Zinc - used for cartridge > Bob, Chip, Joe, Dave, Alan, Taris & everyone else who warned the list about > the infected E-mail from me: THANKS! By mistake I opened an infected > attachment on Fri. Luckily some one told me on the phone about it so I could > get my computer un-infected and an updated anti virus program installed > before I got back on line. It should be back to normal. I hope this did not > cause to much damage to anyone. Thanks again guys for being alert and > spreading the word. > > Fred Kuntz > > > ----- Original Message ----- > From: "Robert Grunau" cgrunau@pathcom.com> > To: "Fred Kuntz" fredkuntz@ncweb.com> > Sent: Friday, October 12, 2001 8:55 AM > Subject: RE: [mg-tabc] Copper to 30 Zinc - used for cartridge > > > > Fred, my anti virus program says you have a VIRUS in the attachment. I did > > not open it, > > Bob > > > > -----Original Message----- > > From: > sentto-1417284-7133-1002894159-cgrunau=pathcom.com@returns.onelist.com > > > [mailto:sentto-1417284-7133-1002894159-cgrunau=pathcom.com@returns.onelist.c > > om]On Behalf Of Fred Kuntz > > Sent: Friday, October 12, 2001 10:47 AM > > To: undisclosed-recipients: ; > > Subject: [mg-tabc] Copper to 30 Zinc - used for cartridge > > > > Ingredients must be very pure. > > 63 Copper to 37 Zinc - a ductile alloy, cheaper than 70/30. Its main uses > > are for drawing into wire, tubes and rods and for rolling into sheet. > > 60 Copper to 40 Zinc - used for castings and extrusions. > > > > > > Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/ > > >