The box
Posted: Tue Sep 25, 2001 5:58 pm
Hi folks,
I am working on a friends TC, and wonder where I can get his steering box
machined and equipped with the needle bearings for the steering arm and
modern oil seal, then reassembled properly.
There is a Russian guy here in the US, but I don't remember his name or
number.
Send those phone numbers.
Best,
Ray McCrary
"Speed is Life;
of course Luck and Altitude
are helpful, too."
----- Original Message ----- From: "Gates Family" janus@iafrica.com> To: Charles_Shiplee@batesuk.com>; "MG-TABC Group" mg-tabc@yahoogroups.com> Sent: Monday, September 24, 2001 11:42 AM Subject: Re: [mg-tabc] Oil Leaks > Seems to me that the higher revs creates a pressurised environment in the > bell housing (or more centrifugal activity in the block) that prevents oil > oozing through (or disperses it away from) the seal. So pulling the engine > would facilitate a solution as the seal is possibly defective. That said, > if idle versus drive time is minimal, defer this backbreaking exercise to a > more appropriate time! > > Joe Gates > TC 8675 > > > > > > > > Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/ > >