Mark McCombs - Dimensions Requested
Posted: Mon Sep 03, 2001 6:36 am
Mark,
I measured from the bolt holes in the rear ply down as you spoke about and got 9.50 inches. My TC is being put together after a ground up restoration. Essentially, I cut my own ash using a bandsaw and I also cut down my own 4' x 8' sheets of marine plywood. The restoration is not yet complete but the tub is.. I hope this helps.
Rob Greaves
Re...
Mayday call...
.. Could the 9.25 dimension from Sherrill suppose to be 9.50, which would lift the body angle (and rear strip) up the .25" it needs? Does anyone out there have a gas tank off that could verify that 9.25 dimention, even though it seems to fit just right at that height? All dimensions came from TC'S Forever.
Frustration reigns currently-
Thanks in Advance
Mark, struggling with TC 8126