TABC Diff Flange.
Posted: Thu May 24, 2001 3:50 am
Is there anybody out there with a diff on the bench.
If so could you please give me a few dimensions from the drive flange.
I need the diameter (external) of the boss where the shaft goes through on
the flange, the centres of the four bolt holes on the the flange across the
diameter and also between a air of holes on the same side,last thing the
maximum external width of the flange measured across the diagonal.
This is laziness on my behalf just so I don't have to dismantle the
propshaft on my car to measure everything.
Regards Roger Muir