Wilsons Sandbox

Posted: **Fri May 18, 2001 4:07 pm**

thanks to those that sent info on how to make engine crank however I got two sizes for the rod stock one said 5/8" the other said 3/4" maybe it is the differece in TC and TD. If some one could check and let me know it would be great . Thsnks for the help. Rolland Meismer TC #3409-TD#5522

Posted: **Fri May 18, 2001 7:59 pm**

Thanks:Austin for the info I think I will try to build a pr. one for each car, I have the torch and lathe and should not be a problem. Rolland

Posted: **Fri May 18, 2001 8:11 pm**

Rolland, the dimension for both cranks ('46 and '49 TC) was .620", or .005 under 5/8" (.625"). Austin ----- Original Message ----- [b]From:[/b] rameismer@aol.com [b]To:[/b] MG Groups [b]Sent:[/b] Friday, May 18, 2001 5:07 PM [b]Subject:[/b] [mg-tabc] re-engine crank thanks to those that sent info on how to make engine crank however I got two sizes for the rod stock one said 5/8" the other said 3/4" maybe it is the differece in TC and TD. If some one could check and let me know it would be great . Thsnks for the help. Rolland Meismer TC #3409-TD#5522 Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/

Wilsons Sandbox

re-engine crank

re-engine crank

Re: re-engine crank

Re: re-engine crank