Page 1 of 1
my TA.s clutch is stuck
Posted: Sat May 05, 2001 3:37 am
by tonygoodall
Jonathan
I expect the cork plate has dried out and the oil become more like glue.
But these plates are surprisingly tough and you may be able to jolt it off
the driven plate by using the starting handle, assuming that you can engage
a gear (ignition off!) I did it this way with my old TA, but it does depend
on just how hard it's stuck.
If you get it off, run the engine regularly, the clutch needs the oil.
Incidentally, if you do finish up taking the clutch out, it's the putting
back that is the most delicate: if you have an original alloy bellhousing,
the final tightening up is the nearest thing you can get to bomb disposal:
you MUST make sure that the clutch withdrawal fork is correctly located
otherwise --- whoops, there goes another TA bellhousing
Regards
Tony TC9825 (ex TA 1001) Birmingham UK
FW: my TA.s clutch is stuck
Posted: Sat May 05, 2001 4:17 am
by tonygoodall
Jonathan
Sorry I did not write what my brain was thinking! The driven plate IS the
cork plate. But jolting it off is the solution.
Tony
----------
> From: tonygoodall tonygoodall@blueyonder.co.uk>
> Date: Sat, 05 May 2001 11:38:11 +0100
> To: mgtabc mg-tabc@yahoogroups.com>
> Subject: my TA.s clutch is stuck
>
> Jonathan
>
> I expect the cork plate has dried out and the oil become more like glue.
> But these plates are surprisingly tough and you may be able to jolt it off the
> driven plate by using the starting handle, assuming that you can engage a gear
> (ignition off!) I did it this way with my old TA, but it does depend on just
> how hard it's stuck.
>
> If you get it off, run the engine regularly, the clutch needs the oil.
>
> Incidentally, if you do finish up taking the clutch out, it's the putting back
> that is the most delicate: if you have an original alloy bellhousing, the
> final tightening up is the nearest thing you can get to bomb disposal: you
> MUST make sure that the clutch withdrawal fork is correctly located otherwise
> --- whoops, there goes another TA bellhousing
>
> Regards
>
> Tony TC9825 (ex TA 1001) Birmingham UK