Hey all, I am in the process of bringing an MG YT back to life. The rear end/brake/axle assembly is very much the same as a TC. I have fitted new rear seals, nuts wheel cylinders and brake shoes per Doug at "from the Frame Up". All went well until I tried to put the brake drum back on. It seems that it fits too tight against the fully retracted new brake shoes. Is there a fix our there I am unaware of? Thanks, Tom, TC 2850.
Brake Drum
-
e_callo
- Posts: 22
- Joined: Mon Feb 04, 2013 7:20 am
Re: Brake Drum
Make sure the E-brake is fully released to start In a message dated 8/30/2016 9:33:36 A.M. Eastern Daylight Time, mg-tabc-noreply@yahoogroups.com writes:
[color=#000000] Hey all, I am in the process of bringing an MG YT back to life. The rear end/brake/axle assembly is very much the same as a TC. I have fitted new rear seals, nuts wheel cylinders and brake shoes per Doug at "from the Frame Up". All went well until I tried to put the brake drum back on. It seems that it fits too tight against the fully retracted new brake shoes. Is there a fix our there I am unaware of? Thanks, Tom, TC 2850. [/color]
Who is online
Users browsing this forum: No registered users and 14 guests