Re: Drop arm [1 Attachment]
-
Doug Pelton
- Posts: 57
- Joined: Sun Dec 21, 2003 12:27 pm
Re: Drop arm [1 Attachment]
Hi Graham, Your drop arm shown in photo is correct. Not bent and has the ball inserted correctly. However you will need to remove the drop arm ball to insert through the end of the drop arm end casing. Once the end assembly is complete then refit the taper into the drop arm. Yes, the drop arm needs to be exactly 90 degrees to the sector shaft. Because you cannot see the orientation of sector shaft inside the box, you can reference a line on bottom of shaft to show the 90 degree mark. New sector shafts do not have this and you will need to remove the box top. You also have the late version of drop arm so all you need to do is have it cracked checked and you should be good. If you need any further assistance, let me know. Best regards, [b][i]Doug Pelton,[/i][/b] ProprietorFrom The Frame Up480-588-8185For Fastest Service: order@fromtheframeup.comLike us on FACEBOOK! See us on YouTUBE! www.FromTheFrameUp.com [b]From:[/b] mg-tabc@yahoogroups.com [mailto:mg-tabc@yahoogroups.com] [b]On Behalf Of [/b]Graham Knight graham.knight5@gmail.com [mg-tabc]
[b]Sent:[/b] Thursday, September 28, 2017 1:40 AM
[b]To:[/b] MG-TABC List mg-tabc@yahoogroups.com>
[b]Subject:[/b] [mg-tabc] Drop arm [1 Attachment] [b][Attachment(s) from Graham Knight included below][/b]
Dear All,
I have attached a photo of my drop arm.
Is it bent? Should the arm be at 90 degrees to the sector shaft?
Which way up should it be; ball up or ball down.
Many thanks for your help.
Graham
[img]https://ec.yimg.com/ec?url=https%3A%2F%2Fipmcdn.avast.com%2Fimages%2Ficons%2Ficon-envelope-tick-round-orange-animated-no-repeat-v1.gif&t=1522511792&sig=0BThqWW1jAoO2bkuvOxM_g--~D[/img] Virus-free. www.avast.com
-
Andrea VILLA
- Posts: 47
- Joined: Sat Dec 24, 2016 3:16 am
Re: Drop arm [1 Attachment]
Attachments :
- [*][url=file:///C:\Users\Steve\AppData\Local\PG Offline 4\Attachments\\DSCN2432.jpg]DSCN2432.jpg[/url]
- [*][url=file:///C:\Users\Steve\AppData\Local\PG Offline 4\Attachments\\$_57 (3a).jpg]$_57 (3a).jpg[/url]
-
Graham Knight
- Posts: 52
- Joined: Mon Feb 04, 2002 4:58 pm
Re: Drop arm [1 Attachment]
Thanks very much Duncan. That's very useful.
Graham
On 28/09/17 23:12, Duncan morelists@yahoo.com [mg-tabc] wrote: > Hi Graham- > Pic taken from next to right front wheel, with front wheels pointed straight ahead. Could not get the entire drop arm in pic, but you get the idea. > Duncan- >
Who is online
Users browsing this forum: No registered users and 11 guests