T pushrod length

[donker@aol.com]

Does anyone know the operating length of pushrods for the XPAG and XPEG engines? The length I need is that from the contact point at the cam follower to the contact point at the rocker adjuster, not the overall length. Thanks...Bill Bollendonk, Littleton, Colorado USA

[Malcolm Taylor]

Bill, I am just catching up with e-mails after some 10 days 'off-line'. I agree with Clive's comments but would recommend a little 'trial and error' with careful measurement to give the correct angle of attack (see comments by Neil Cairns, Stephen Cooper and Carl Cederstrand in Octagon Bulletins #362,364,377) for your individual engine. After skimming the head and fitting a Crane cam to my XPAG a few years ago I ran for some time with packing pieces under the pedestals before doing this. After fitting the shorter rods the change in performance was marked. Best wishes, Malcolm

----- Original Message ----- From: donker@aol.com> To: mg-tabc@yahoogroups.com> Sent: Tuesday, November 20, 2001 12:05 AM Subject: [mg-tabc] T pushrod length > Does anyone know the operating length of pushrods for the XPAG and XPEG > engines? The length I need is that from the contact point at the cam follower > to the contact point at the rocker adjuster, not the overall length. > Thanks...Bill Bollendonk, Littleton, Colorado USA > > > > Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/ > > > >