clutch problem - need advice
Posted: Fri Aug 03, 2007 7:14 am
I don't have a manual in front of me to look at but since you have
the clutch cover off the motor and all seems ok from what you
describe a problem I had in the past actually a couple of times with
a couple of old two strokes was the large nut that holds the clutch
basket on coming slightly loose which allowed the basket to move in
and out a little when you pulled in the clutch preventing the clutch
from disengaging..hope this is the case for you as this is and easy
fix. If I remember right there was a tab washer behind this nut on
these bikes that you bend over the flat on the nut like just like on
the countershaft sprocket. On these bikes, one a kawasaki triple and
the other a Can-Am I think this washers was never properly bent over
the nut at the factorywhich allowed the nut to turn. Have a great
day....Greg
--- In DSN_KLR650@yahoogroups.com, "bradster62"
wrote:
the> > I've lurked on this forum for a long time and have learned a great > deal from many of you. I am now in my time of need.... > > 05' KLR, 14,000 miles > > While riding the other day, I reached for the clutch, pulled, and
best> clutch lever went to the bar with no resistance. I thought I had a > broken clutch cable. However, that's not the problem. I'll do my
clutch.> to describe it. Using the clutch diagram at > http://www.ronayers.com/fiche/400_0479/clutch/clutch.cfm? > man=ka&groupid=6320&parent=6210. > > The engine-end of the clutch cable attaches to the lever on the > #13102 RELEASE-COMP-CLUTCH. Internal to the engine, this thingy > engages with a #46102 rod which is involved with releasing the
that> > I removed the clutch cable from the lever on the#13102 and find
side> there is no tension when I pull on the lever. I opened the right
either> of the engine and everything looks fine. No noticeable wear on
in/out> the #13102 or #46102. I do find that I can pull the #46102 rod
Should> about a 1/2 inch or so from the center of the clutch housing.
engage> this rod be tensioned by the clutch spring and not easily pulled? > > Any ideas on the cause of this problem? I've pulled the #13102 out > and tried to reseat it per the OEM manual. It does not seem to
> even after a couple of attempts. > > Incidentally, I cleaned the oil screen of the usual spaghetti. No > serious blockage. Just strands of sealant and chunks of hard rubber. > > Thanks, > Bradster >