Page 1 of 1
throttle sticking after accident
Posted: Wed May 23, 2007 2:39 pm
by Vladimir Vega III
I'm still not finished recovering from my encounter with the dog. My ankle still hurts to rotate inwards. The doctor thinks the puncture wound to the calf might have done a little damage to the muscle, since the tendons hurt when I turn my foot inwards, and it "will take some time to heal completely." I also think I sprained my ankle--part of the issue, but I can walk much better now.
Can't wait to get on my baby. We look at each other every day. I even took her for a walk the other day--turned her on, warmed her up, and walked her around a couple of palm trees. She got so excited that she almost got ahead of me--I had to limp/run to keep up. You see, I was on the left side of the bike and the front brake is shifted downward, so when I tried to rein her in, I couldn't reach the front brake--much less the rear brake. We made it OK. She's getting anxious, as am I.

WOW, I guess we've bonded!
BUT, getting to my question/comment:
The throtle will not zero back when I let go of it. Would this be an easy fix? what could it be? I'm still a bit clueless about motorcycle mechanics. My Nissan 240SX, well, I know that vehicle pretty well.

Vlad
In Riverside, CA
____________________________________________________________________________________Yahoo! oneSearch: Finally, mobile search
that gives answers, not web links.
http://mobile.yahoo.com/mobileweb/onesearch?refer=1ONXIC
throttle sticking after accident
Posted: Wed May 23, 2007 2:56 pm
by Jim Priest
On 5/23/07, Vladimir Vega III wrote:
> The throtle will not zero back when I let go of it. Would this be an easy fix? what could it
Stuck throttle cable. You mention an encounter with a dog - did you
drop it on that side??
I'd check the area near the throttle and see if that housing is
cracked, etc... It's fairly easy to pop it open and check the routing
of the cables internally as well. If you dropped it - it may be the
throttle tube is rubbing on the handlebar. You can loosen the entire
throttle assembly and slide it over a bit.
Jim
throttle sticking after accident
Posted: Wed May 23, 2007 4:10 pm
by Jeff Saline
On Wed, 23 May 2007 11:39:16 -0700 (PDT) Vladimir Vega III
writes:
> I'm still not finished recovering from my encounter with the dog. My
> ankle still hurts to rotate inwards. The doctor thinks the puncture
> wound to the calf might have done a little damage to the muscle,
> since the tendons hurt when I turn my foot inwards, and it "will
> take some time to heal completely." I also think I sprained my
> ankle--part of the issue, but I can walk much better now.
>
> Can't wait to get on my baby. We look at each other every day. I
> even took her for a walk the other day--turned her on, warmed her
> up, and walked her around a couple of palm trees. She got so
> excited that she almost got ahead of me--I had to limp/run to keep
> up. You see, I was on the left side of the bike and the front brake
> is shifted downward, so when I tried to rein her in, I couldn't
> reach the front brake--much less the rear brake. We made it OK.
> She's getting anxious, as am I.

WOW, I guess we've bonded!
>
> BUT, getting to my question/comment:
> The throtle will not zero back when I let go of it. Would this be
> an easy fix? what could it be? I'm still a bit clueless about
> motorcycle mechanics. My Nissan 240SX, well, I know that vehicle
> pretty well.

>
> Vlad
> In Riverside, CA
<><><><><><><><>
<><><><><><><><>
Vlad,
I think I'd take a look at the position of the right hand controls. I'd
probably loosen them a tad and try to slide the throttle assembly
outboard a smidge. I'm wondering if the throttle tube is rubbing on the
end of the handlebar.
Best and good luck with your continued recovery,
Jeff Saline
ABC # 4412 South Dakota Airmarshal
Airheads Beemer Club
www.airheads.org
The Beautiful Black Hills of South Dakota
75 R90/6, 03 KLR650, 79 R100RT
j.c.whitney travel trunk
Posted: Wed May 30, 2007 8:55 pm
by Vladimir Vega III
I couldn't find the original post from John. I'm interested to know the details on getting those Pelican cases--I like the way they look (and probably cheaper than the alumninum paniers, right?). Also, what is needed to install them on a stock KLR.
Thanks,
Vladimir
----- Original Message ----
From: revmaaatin
To:
DSN_KLR650@yahoogroups.com
Sent: Wednesday, May 30, 2007 8:18:43 AM
Subject: [DSN_KLR650] Re: j.c.whitney travel trunk
--- In DSN_KLR650@yahoogro ups.com, "John Biccum" wrote:
SNIP
>
> BTW after 40K miles of (ab)use I replaced my Givi A36s with Pelican
cases.
> I think the Pelicans can take more than I can:
>
http://johnbiccum. smugmug.com/ gallery/2549433# 136747357
>
Hi John,
Nice post, and great pictures (as always), to include this caption
"Bike survived the cartwheeling high side with no damage except for one
broken mirror" supporting the link above.
Q. So, how does one survive a cartwheeling high side with little
damage, etc. Q = stroy-time details (please).
revmaaatin.
____________________________________________________________________________________Yahoo! oneSearch: Finally, mobile search
that gives answers, not web links.
http://mobile.yahoo.com/mobileweb/onese ... fer=1ONXIC
[Non-text portions of this message have been removed]