Wilsons Sandbox

Posted: **Mon Feb 11, 2002 3:19 pm**

I got both the bash plate and the fork brace in today. They went on in about a half an hour total! Not a hard install of course. I get to test them out on the grueling treck to work (tampa's paved roads are worse than many dirt roads!) so we shall see how they fare.

Thanks for the rapid shipping and straight-forward insight. I will definitely do business with you again! -Myk [Non-text portions of this message have been removed]

Posted: **Mon Feb 11, 2002 3:27 pm**

I got both the bash plate and the fork brace in today. They went on in about a half an hour total! Not a hard install of course. I get to test them out on the grueling treck to work (tampa's paved roads are worse than many dirt roads!) so we shall see how they fare.

Thanks for the rapid shipping and straight-forward insight. I will definitely do business with you again! -Myk Btw, that was to Fred Hink, Arrowhead. The items got here exactly when he said they would and were exactly as he described. No wonder he's so popular with the aftermarket around here! ____________________ Always try to be modest, and be proud of it! [Non-text portions of this message have been removed]

Posted: **Thu May 30, 2002 12:32 pm**

My dry battery is gone and a new (wet) one is powering the bike - I was over-charging the bike with a cheap *trickle charger* which turns out to be nothing less than a low voltage arc welder! I dried the battery out so many times it held only 11.5v for a few starts then went flat. I thought I was killing it with the voltage regulator on the bike, but it was I. I measured the voltage across the posts (connected to the leads) installed in the bike. Not running: 12.3v 1000~2000 rpm: 12.2~12.7v 2000~3000 rpm: 13.2~14.3v 3000 rpm and up: 12.5~12.7v Regulator seems ok to me. I want to thank the list and specially those who took their time to take the extra step to help out off line. Thank you! Rev. Chuck :^)>+

Posted: **Mon Jul 22, 2002 12:16 pm**

----- Original Message ----- From: To: Sent: Monday, July 22, 2002 11:02 AM Subject: Thanks! > Jake, > Just wanted say "Howdy" and thank you for the superb > Idler lever! Very nice work, fit like a glove and very > obviously a much more robust part. I very luckily had no > failure of the original lever "YET", but Man-O-Man was > it a nasty looking part. I am quite surprised it had not > yet failed. The weld looked like it was done by Chimp > and talk about brittle! > > Thanks to you, Elden and the Listers for the info > brought to light--saved me a lot of potential > aggravation. > > Thanks again, > Frank >

Posted: **Tue Aug 24, 2004 4:43 pm**

Your file is attached. ++++ Attachment: No Virus found ++++ Norman AntiVirus - www.norman.com [Non-text portions of this message have been removed]

Posted: **Thu Oct 14, 2004 2:52 pm**

Thanks for the replies on the clutch cable... Who is Fred and what is the Arrowhead website? I'm growing increasingly frustrated as this id about the 12th time I've tried to post this... my posts never show up!!! ~Eric

Posted: **Thu Oct 14, 2004 2:58 pm**

> > > Thanks for the replies on the clutch cable... Who is Fred and what > is the Arrowhead website? I'm growing increasingly frustrated as > this id about the 12th time I've tried to post this... my posts > never show up!!! > ~Eric > >Here you go http://www.arrowheadmotorsports.com/

Bogdan

Posted: **Thu Oct 14, 2004 3:01 pm**

On Thu, 14 Oct 2004, Eric wrote:

> Thanks for the replies on the clutch cable... Who is Fred and what > is the Arrowhead website? I'm growing increasingly frustrated as > this id about the 12th time I've tried to post this... my posts > never show up!!! > ~Eric

Your posts might show up if your yahoo.com mail address didn't bounce virtually every EMAIL sent to it. -Eric

Posted: **Thu Oct 14, 2004 11:41 pm**

"Eric L. Green" wrote:

On Thu, 14 Oct 2004, Eric wrote: > Thanks for the replies on the clutch cable... Who is Fred and what > is the Arrowhead website? I'm growing increasingly frustrated as > this id about the 12th time I've tried to post this... my posts > never show up!!! > ~Eric Your posts might show up if your yahoo.com mail address didn't bounce virtually every EMAIL sent to it. -Eric Pardon me but that should read Super Fred. List sponsored by Dual Sport News at www.dualsportnews.com. List FAQ courtesy of Chris Krok at: www.bigcee.com/klr650faq.html Unsubscribe by sending a blank message to: DSN_klr650-unsubscribe@yahoogroups.com . Yahoo! Groups Links Howard A-18 (christine A-18) --------------------------------- Do you Yahoo!? Yahoo! Mail CNET Editors' Choice 2004. Tell them what you think. a [Non-text portions of this message have been removed]

Posted: **Thu Oct 14, 2004 11:41 pm**

"Eric L. Green" wrote:

On Thu, 14 Oct 2004, Eric wrote: > Thanks for the replies on the clutch cable... Who is Fred and what > is the Arrowhead website? I'm growing increasingly frustrated as > this id about the 12th time I've tried to post this... my posts > never show up!!! > ~Eric Your posts might show up if your yahoo.com mail address didn't bounce virtually every EMAIL sent to it. -Eric Pardon me but that should read Super Fred. List sponsored by Dual Sport News at www.dualsportnews.com. List FAQ courtesy of Chris Krok at: www.bigcee.com/klr650faq.html Unsubscribe by sending a blank message to: DSN_klr650-unsubscribe@yahoogroups.com . Yahoo! Groups Links Howard A-18 (christine A-18) --------------------------------- Do you Yahoo!? Yahoo! Mail CNET Editors' Choice 2004. Tell them what you think. a [Non-text portions of this message have been removed]

Wilsons Sandbox

nklr geocaching/gps

thanks!

thanks!

thanks!

thanks!

thanks!

thanks!

thanks!

thanks!

thanks!

thanks!