Page 1 of 1
distanzia really pissing me off !
Posted: Sat Jul 29, 2006 6:01 pm
by ned
Just venting here but I cannot get those friggin Distanzias to seat
the bead on my KLR rims - tried everything: soap, dish soap, WD-40,
tire lube, motor honey, melted cheese, all things slippery - still no
pop onto the rim - they just won't quite do it - I can lift the bead
where it was low and then the low spot moves to the other side of the
tire - carumba !!! These are some tight dogs indeed.
Anyone had sucess / failure stories to share?
distanzia really pissing me off !
Posted: Sat Jul 29, 2006 6:13 pm
by Carlos Rigdon
How much air are you putting them ? Mine popped up with 25 or less
On 7/29/06, ned wrote:
>
> Just venting here but I cannot get those friggin Distanzias to seat
> the bead on my KLR rims - tried everything: soap, dish soap, WD-40,
> tire lube, motor honey, melted cheese, all things slippery - still no
> pop onto the rim - they just won't quite do it - I can lift the bead
> where it was low and then the low spot moves to the other side of the
> tire - carumba !!! These are some tight dogs indeed.
>
> Anyone had sucess / failure stories to share?
>
>
>
[Non-text portions of this message have been removed]
distanzia really pissing me off !
Posted: Sat Jul 29, 2006 6:51 pm
by revmaaatin
--- In
DSN_KLR650@yahoogroups.com, "ned" wrote:
>
> Just venting here but I cannot get those friggin Distanzias to seat
> the bead on my KLR rims - tried everything: soap, dish soap, WD-40,
> tire lube, motor honey, melted cheese, all things slippery - still
no
> pop onto the rim - they just won't quite do it - I can lift the bead
> where it was low and then the low spot moves to the other side of
the
> tire - carumba !!! These are some tight dogs indeed.
>
> Anyone had sucess / failure stories to share?
>
Hi NED,
Not specifically with Distanzias, but when you had the tire off, was
there a lot of old tire residue on the wheel, black gummy stuff, and
did you clean it off? Sometimes the gummy residue keeps the tire
from moving out on the rim smoothly and from seating. The last tire
I did was under the supervision of Coach Saline, and I can tell you,
a clean rim was a lot easier to seat the bead than the previous time,
when I did it, and ignored the gummy residue.
Some time ago, I heard someone else describe this, and finally rode
the tire without the bead being fully seated (I WOULD BE VERY LEARY
OF DOING SO>>>JUST REPEATING WHAT THEY DID) I think it was a trail
side repair. They indicated that it seated a short time later.
YES, YMMV greatly with this last ditch effort.
What is not known to me, is how much danger you are in in pinching a
tube, riding on it when the bead would not seat. or worse. Others
for comment? Trail side, I would go for it, because I already know
that I am not going to push the green pig much further than -out-of-
the-roadway, contray to anothers suggestion that they would not push
it more than 5-6 miles.
revmaaatin.
adjustable front brake lever options?
Posted: Sat Jul 29, 2006 8:49 pm
by Jay Martin
Hi,
I'm looking for an alternative front brake lever setup where my
fingers don't have to reach so far. Any recommendations?
Thanks,
Jay
2004 KLR650